Centro 3 User manual

Centro 3Assembly Instructions
(with spacer bars)

1
Stand base on the ground.
Loosen grub screws and slide
both connector bars half way
out of groove and retighten.
Repeat for other base posts.
Note: Base plates
pre-assembled on kits
supplied in carry bag only.
2
The upper 8-way post end
cap has two notches which
should align with the
connector bar grooves
shown in stage 3.
3
Join posts and tighten the
grub screws to make
assembly secure.
Repeat for other base posts.

4
Slot spacer bars into
assembled post approx
150mm from top and base.
Tighten the grub screws to
lock into place.
6
Slot vertical rails onto spacer
bars leaving space at bottom
for the horizontal graphic
rail. Secure in place by
tightening grub screws.
Single strip line should be
on the edge closest to post
when viewed from front.
5
The side straight vertical
graphic rails should now be
assembled. Note position of
graphic fixing strips, which
should align.

7
Connect first horizontal
rails to vertical rails and
tighten grub screws as
before. Adjust height of
vertical rails if necessary to
ensure assembly is square.
8
Slot second horizontal rails
onto all vertical rails and
tighten grub screws.
9
Affix graphic panels to
the graphic fixing strips,
starting from the top and
side, working across the
completed system.

Centro 3Assembly Instructions
(no spacer bars)

1
Stand base on the ground.
Loosen grub screws and slide
both connector bars half way
out of groove and retighten.
Repeat for other base posts.
Note: Base plates
pre-assembled on kits
supplied in carry bag only.
2
The upper 8-way post end
cap has two notches which
should align with the
connector bar grooves
shown in stage 3.
3
Join posts and tighten the
grub screws to make
assembly secure.
Repeat for other base posts.

4
Remove four internal clamps
from the spacer bars by
removing grub screw and
sliding out.
5
Insert internal clamps into
both ends of the 750mm
horizontal rails and secure
by inserting grub screw and
tightening (not fully).
6
Connect first horizontal
rails at the bottom of posts,
leaving a 10mm gap between
underside of rail and surface
of base plate. Tighten clamp
screws to secure in place.

8
Connect assembled vertical
rails to the bottom horizontal
rail. Single strip line should
be on the edge closest to the
post when viewed from the
front.
7
The side straight 950mm
graphic rails should now
be assembled. Note
position of graphic fixing
strips, which should align.
9
Slot second horizontal rails
onto all vertical rails and
fit clamps into 8-way post.
Tighten clamp screws to
secure assembly.
10
Affix graphic panels to the
graphic fixing strips,
starting from the top and
side, working across the
completed system.