Channel Vision 6010 User manual

500-000 Rev B
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or workmanship which occurs
during normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from
the date of original purchase. This is a no hassle warranty with no mail in warranty card needed. This
warranty does not cover damages in shipment, failures caused by other products not supplied by Channel
Vision Technology, or failures due to accident, misuse, abuse, or alteration of the equipment. This warranty
is extended only to the original purchaser, and a purchase receipt, invoice, or other proof of original
purchase date will be required before warranty repairs are provided.
Mail in service can be obtained during the warranty period by calling [phone] toll free. A Return
Authorization number must be obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other rights (which vary from state to state).
If a problem with this product develops during or after the warranty period, please contact Channel Vision
Technology, your dealer or any factory-authorized service center.
*:
Image Sensor:
Picture Elements:
Resolution:
S/N Ratio:
Min Illumination:
Electronic Shutter:
Iris Control:
Gamma Characteristic:
Humidity:
Dimensions:
Operating Temp:
Specifications
Sony 1/3” Super HAD CCD
NTSC: 510x492
420 lines
More than 46 dB
0.1 LUX
1/60s - 1/100,000s
Automatic
0.45
RH 95% max.
2.75” x 3.30” x 7.50” (70mm x 84mm x 190mm)
-10°C to 50°C (14°F to 122°F)
*Specifications subject to change without notice.
White Balance:
Lens:
Sync. System:
Power Requirements:
Power Consumption:
Video Output:
Automatic
Varifocal, 4-9mm
Internal
12VDC
120mA
1 Vp-p @ 75 ohms
6010
Varifocal Bullet Camera
8

2
The is a Varifocal Bullet Camera. Its 4-9mm varifocal
lens and low light sensitivity make it ideal for CCTV
installations with minimal ambient light where precise camera
adjustments are needed. Typical applications include entry
gates, driveways, patios, and backyards.
6010
6010 Varifocal Bullet Camera Includes
Swivel Mount
Camera
Power Supply
Screws Anchors
Features:
Sony 1/3” Super HAD CCD sensor
420 TV lines of resolution
4-9mm varifocal lens
Works with 5040 illuminator for night viewing
Easy to install
h
h
h
h
h
3
Model
6010
1. Mount base
2. Connect camera and swivel mount
3. Connect wiring
4. Point camera and adjust the lens
Installation:
Drill a hole for wiring to exit the wall or ceiling.
Attach the base of the swivel mount using the screws
provided.
If necessary, attach the camera’s video output to a coax
extension that is long enough to reach your monitor or
video distribution equipment.
If necessary, cut the connector off of the end of the power
supply and splice in an extension using crimp-on
connectors.
Mount the base to the ceiling.
Screw the swivel mount into the base (see diagram).
Point the camera body and adjust the lens view.
h
h
h
h
h
h
h
2-Conductor power
supply extension
(not included)
Crimp-on splice
connectors
(not included)
To Monitor
or
Video distribution
Power supply
(included)
Coax extension
(not included)
BNC connector
Base

2
The is a Varifocal Bullet Camera. Its 4-9mm varifocal
lens and low light sensitivity make it ideal for CCTV
installations with minimal ambient light where precise camera
adjustments are needed. Typical applications include entry
gates, driveways, patios, and backyards.
6010
6010 Varifocal Bullet Camera Includes
Swivel Mount
Camera
Power Supply
Screws Anchors
Features:
Sony 1/3” Super HAD CCD sensor
420 TV lines of resolution
4-9mm varifocal lens
Works with 5040 illuminator for night viewing
Easy to install
h
h
h
h
h
3
Model
6010
1. Mount base
2. Connect camera and swivel mount
3. Connect wiring
4. Point camera and adjust the lens
Installation:
Drill a hole for wiring to exit the wall or ceiling.
Attach the base of the swivel mount using the screws
provided.
If necessary, attach the camera’s video output to a coax
extension that is long enough to reach your monitor or
video distribution equipment.
If necessary, cut the connector off of the end of the power
supply and splice in an extension using crimp-on
connectors.
Mount the base to the ceiling.
Screw the swivel mount into the base (see diagram).
Point the camera body and adjust the lens view.
h
h
h
h
h
h
h
2-Conductor power
supply extension
(not included)
Crimp-on splice
connectors
(not included)
To Monitor
or
Video distribution
Power supply
(included)
Coax extension
(not included)
BNC connector
Base

500-000 Rev B
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or workmanship which occurs
during normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from
the date of original purchase. This is a no hassle warranty with no mail in warranty card needed. This
warranty does not cover damages in shipment, failures caused by other products not supplied by Channel
Vision Technology, or failures due to accident, misuse, abuse, or alteration of the equipment. This warranty
is extended only to the original purchaser, and a purchase receipt, invoice, or other proof of original
purchase date will be required before warranty repairs are provided.
Mail in service can be obtained during the warranty period by calling [phone] toll free. A Return
Authorization number must be obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other rights (which vary from state to state).
If a problem with this product develops during or after the warranty period, please contact Channel Vision
Technology, your dealer or any factory-authorized service center.
*:
Image Sensor:
Picture Elements:
Resolution:
S/N Ratio:
Min Illumination:
Electronic Shutter:
Iris Control:
Gamma Characteristic:
Humidity:
Dimensions:
Operating Temp:
Specifications
Sony 1/3” Super HAD CCD
NTSC: 510x492
420 lines
More than 46 dB
0.1 LUX
1/60s - 1/100,000s
Automatic
0.45
RH 95% max.
2.75” x 3.30” x 7.50” (70mm x 84mm x 190mm)
-10°C to 50°C (14°F to 122°F)
*Specifications subject to change without notice.
White Balance:
Lens:
Sync. System:
Power Requirements:
Power Consumption:
Video Output:
Automatic
Varifocal, 4-9mm
Internal
12VDC
120mA
1 Vp-p @ 75 ohms
6010
Varifocal Bullet Camera
8