Chicco Take-A-Seat User manual

Take-A-Seat™
3-in-1 Travel Seat
Owner's Manual
Read all instructions BEFORE
assembly and USE of product.
KEEP INSTRUCTIONS FOR
FUTURE USE.
IS0198E_01 ©2020 Artsana USA, INC. 05/20
www.chiccousa.com

3
2
Parts List
A.
B.
C.
A. - Seat Base
B. - Backrest
C. - Tray
CHAIR BOOSTER Mode FLOOR SEAT Mode
TODDLER CHAIR Mode
WARNINGFailure to follow the warnings and the instructions
throughout this booklet could result in serious injury or death. Each mode
has specific warnings, make sure to read and understand the warnings in
each mode.
This product can be used in the following modes:

4 5
1
1. Unfasten the Rear Attachment
Straps.
2. Rotate the Rear Legs out until
they click into place.
2
Components Assembling the Seat
A - Backrest
B - Rear Attachment straps
C - Tray Release Buttons
D - Seat Height Adjustment Buttons
E - Lower Attachment straps
F - Seat Pad
G - Harness Straps
H - Tray Supports
I - Horn Release Lever
J - Seat Release Lever
K - Tray Attachments
L - Tray Horn
M - Harness Strap Storage
A
B
C
M
D E
L
F
K
G
H I
J
“CLICK!”
“CLICK!”

6 7
3
3. Flip the chair upright and locate
the Locking Lever on the bottom of
the seat base as shown. Squeeze
the Locking Lever and rotate the
seat base up until it clicks into place.
4
4. To attach the Backrest to the seat
frame, first line up the seat frame
down tubes with the corresponding
openings on the Backrest. Next,
guide both Backrest openings onto
the top of the down tubes. Then
line up the plastic side tabs with the
grooves on the Seat Frame, as shown.
Press down on the Seat Backrest until
both snap buttons click into place.
Pull up on the Backrest to make sure
it is securely attached.
Assembling the Seat Assembling the Seat
“CLICK!”
“CLICK!”

8 9
5
5. Pull the Seat Fabric sleeve up and
over the Backrest and hook the fabric
button holes over the 3 Backrest Tabs,
as shown.
Assembling the Seat Assembling the Seat
6A. To attach the Tray to the seat
frame, line up theTray Hubs with the
Tray Supports. Slide both Tray Hubs
onto the Supports until they click into
position. Pull out on the tray to make
sure it is securely attached.
WARNING
The tray is not designed to hold the child in the chair.
6A“CLICK!”
“CLICK!”

10 11
6B. Lift up on the front edge of the
Tray and locate the Tray Horn on the
bottom of the Tray. Flip the Tray Horn
down and insert theTray Horn into
the front of the Seat Base, as shown.
Make sure theTray Horn clicks into
Place. Pull up on the tray to make
sure it is securely attached.
Assembling the Seat
WARNING
IMPORTANT FOR YOUR CHILD'S SAFETY - Always insert the Tray Horn into the
Seat Base before using the Tray.
7A. To adjust the seat height to
a higher position, pull up on the
Backrest to the desired height.
7B. To adjust the seat height to a
lower position, squeeze both side
adjustment locks and slide the seat
down to the desired height.
Make sure the seat locks into one of
the 3 positions.
Adjusting the Height of the Seat
WARNING
Do Not adjust the seat height with the child sitting in the seat. Keep your child
at a safe distance when adjusting the height of the seat. Make sure that both
side locks have locked into place and are at the same height, before placing your
child in the seat.
6B
7B
7A

13
12
BOOSTER SEAT USE
Children have suffered severe head
injuries, including skull fractures, after
falling with or from boosters.
• Check that booster seat is securely
attached to adult chair before each
use.
• Always use restraints until child is
able to get in and out of booster seat
without help. Adjust to fit snugly.
• Never allow child to push away from
table.
• Never lift and carry child in booster
seat.
• Stay near and watch your child
during use.
• Until child is able to get in and out of
the booster seat without help (about
2 ½ years old), the child should be
secured in the booster seat at all
times by the restraint system.The
tray is not designed to hold the child
in the chair.
• Never allow child to sit in unsecured
chair. Always secure the booster
seat to chair using both attachment
straps. Always check that the
attachment is secure before each
use.
• Prevent serious injury or death. Do
not use in motor vehicles.
• Use this booster only for children
capable of sitting upright unassisted.
• Do not use for children weighing
more than 50 lbs (22.7 kg).
• Do not use on any elevated surface
other than a full sized dining room
chair.
• Never fit the booster seat to
damaged or unstable chairs, folding
chairs, pedestal chairs or bar stools.
• Only use on chairs with a seat at
least 14 inches wide, 15 inches deep,
and a backrest at least 13 3/4 inches
high.
• Always check that the surface of the
floor is even and the chair is stable
before fitting the booster seat to the
chair.
• Do not use the product if any part is
broken, torn, or missing.
• Ensure that all components are
correctly fitted and adjusted before
use.
• To avoid the danger of suffocation,
remove all plastic covers before using
the product.
• Do not leave the product near walls,
curtains, or windows, where the child
can become entangled.
• Do not attach any parts to the
product that are not supplied or
expressly approved by Chicco.
WARNING
8. Center the seat on the chair,
making sure the back of the seat is
against the seat back.
9A. Fasten the Rear Attachment
Straps, passing them behind the
backrest of the chair. Pull the Rear
Attachment Strap snug - Do not fully
tighten.
9B. Then fasten the Lower
Attachment Straps, passing them
underneath the seat of the chair.
Pull the Lower Attachment Strap
snug - Do not fully tighten.
8
Attaching the Booster Seat to a Chair
9A
9B

14 15
11A. Locate the locking tab under the
front of the seat base. Push the tab
back and pull up on the Tray Horn to
remove from the seat. Flip the Tray
Horn up to store and lay flat under
the Tray.
11B. To remove the Tray from the
Seat Frame, locate the release
buttons on both sides of the Tray
Hubs. Press both release buttons at
the same time and pull on the tray to
remove it from the Tray Supports.
Note: the tray must be level to
expose release buttons.
Removing the Tray
11A
11B
10. To ensure the seat is securely
attached to the chair, tighten the
Rear and Lower Attachment Straps
as shown.
Once tight, pull on the seat and
make sure attachment straps do not
become loose. If they become loose,
reposition the straps and retighten to
make sure the straps do not become
loose.
10
Attaching the Booster Seat to a Chair

17
16
FLOOR SEAT USE
FALL HAZARD: Infants have suffered
skull fractures falling while in and
from floor seats.
• Use ONLY on the floor.
• NEVER use on an elevated surface.
• ALWAYS use restraints. Adjust to fit
snugly.
• NEVER lift or carry child in the
product.
• Use ONLY with a child that is able to
hold their head up unassisted.
• Do not use for children weighing
more than 50 lbs (22.7 kg).
• STOP using as a floor seat when the
child can climb out or walk.
• ALWAYS keep child in view while in
product.
• Do not use the product if any part is
broken, torn, or missing.
• Ensure that all components are
correctly fitted and adjusted before
use.
• To avoid the danger of suffocation,
remove all plastic covers before using
the product.
• Do not leave the product near walls,
curtains, or windows, where the child
can become entangled.
• Do not attach any parts to the
product that are not supplied or
expressly approved by Chicco.
DROWNING HAZARD: Infants have
drowned when floor seat has been
placed in a bath tub or pool.
• NEVER use in or near water.
WARNING
12A. Unfasten the 3-point
harness by squeezing the prongs on
both sides.
12B. Slide both Waist Clips into the
Crotch Strap Buckle. Pull on both
sides to make sure the Clips are
secured to the Buckle.
12C. Adjust the 3-point harness to fit
your child.
Using the 3-point Harness
12A
12C
12B

19
18
TODDLER CHAIR USE
• Use ONLY on the floor.
• NEVER use on an elevated surface.
• Do not use for children weighing
more than 50 lbs (22.7 kg).
• ALWAYS keep child in view while in
product.
• Do not use the product if any part is
broken, torn, or missing.
• Ensure that all components are
correctly fitted and adjusted before
use.
• To avoid the danger of suffocation,
remove all plastic covers before using
the product.
• Do not leave the product near walls,
curtains, or windows, where the child
can become entangled.
• Do not attach any parts to the
product that are not supplied or
expressly approved by Chicco.
• DROWNING HAZARD: NEVER use
in or near water.
WARNING
13
13. To remove the Rear and Lower
Attachment Straps, press in on the
release button and at the same time,
pull out the Attachment Strap buckle.
Repeat for the other 3 Attachment
Strap buckles. Store the straps for
later use.
Refer to previous section for tray
removal (steps 11A and 11B).
Refer to previous section for
restraint use (steps 12A, 12B and
12C).
Removing the Attachment Straps