Chicco MyFit Zip User manual

PMS 2747 and PMS 186
WARNING: Avoid serious injury or death to your child. Never
use your MyFit Zip Child Restraint without the softgoods in place.
You must read and understand the Softgood Removal instructions
and the instructions in the User Guide. If you do not understand
these instructions, DO NOT attempt to remove the softgoods,
STOP and call Chicco at 1-877-424-4226.
INSTRUCTIONS: MyFit Zip Softgoods Removal/Installation
IMPORTANT: Please also refer to the instructions that came with your product.
Completely loosen Harness by pressing Harness
Release Button on the front of the Child Restraint and
pulling out on both of the Harness Straps. Then unbuckle
the Chest Clip and Harness Buckle.
1Undo the hook and loop fastener on BOTH Waist
Belt pads and remove.
2
Unhook the hook and loop Tab and remove BOTH
Shoulder Pads.
3Remove the Crotch Strap Pad
by pushing the fabric Tab
through the slot on the BACK of the Harness Buckle. Then
pull the Tab out of the FRONT and remove Crotch Strap Pad.
4
1
SS0019E_01
SOFTGOODS REMOVAL:
Remove the Seat Back Pad by unzipping the pad at the
top of the headrest. Then unhook both hook and loop tabs
near the Shoulder Belt Guides.
5
Remove the Seat Bottom Pad by unzipping the pad at the
back and front of the seat bottom. Thread the Crotch Strap
down through the fabric and remove the Pad.
6

2
With the Headrest in the highest position, locate
the elastic strap on the BACK of the Headrest and
unhook by pulling up on the fabric tab. Repeat this step
for the other elastic strap.
10
Pull back gently on both of the plastic tabs at the
top of the Headrest and pull up on the Headrest fabric.
11 Remove the Headrest Fabric Pad, as shown.
12
Unhook the Armrest fabric loop from the side hook
located near the vehicle belt path. Repeat this step for the
other side. TIP: To Assist in the removal of the Armrest
fabric, push back on the fabric while removing the loop.
13 Undo the snap attaching the Armrest Fabric to the
Backrest Seat Pad and then remove the Armrest Fabric.
Repeat this step for the other Armrest.
14
Thread the Crotch Strap down through the fabric and
pull the FABRIC up around the front and sides of the seat.
Then pull fabric around the Harness Adjuster Strap Cover
and remove the Seat Bottom Pad. The plastic Harness
Adjuster Strap Cover is NOT removable.
9
Lift up on the Seat Bottom Pad, undo both
elastic straps attached to the Latch Storage
Compartment. Close the Compartment door.
8
Remove BOTH of the cup holders by pressing the
orange button located on the bottom edge of the Cup
Holder and lifting up.
7

3
Fully recline the seat (position 1). Turn the Child Restraint over and locate the crotch strap metal bar. Turn metal bar
slightly and get corner to go through slot. Push metal bar through slot while pulling crotch belt out.
NEVER use Child Restraint without the Crotch Strap installed.
CROTCH STRAP REMOVAL:
Unhook BOTH elastic straps on the back of the Child
Restraint. Pull the fabric out gently from the groove
around the Child Restraint. Repeat for the other side.
15
Remove the Backrest Seat Pad from the Child Restraint.
NEVER use Child Restraint without the Seat Pad.
17
Unhook the elastic strap from the side hook and the
top hook located near the vehicle belt path. Repeat for
the other side.
16
Fabrics may be hand washed using mild soap and water, or machine washed in cold water on delicate cycle using mild
detergent. Hang to dry. DO NOT BLEACH. Please consult your product manual for additional care and maintenance
instructions.
DO NOT remove the Harness Straps, Chest Clip, and Chest Clip pads. The Chest Clip Pads can be easily spot cleaned with
warm water and mild soap. Contact Chicco Customer Service at 1-877-424-4226 for assistance or additional information.
Cleaning Instructions:
18

4
Place the Backrest Seat Pad onto the Child Restraint.
1Hook the elastic strap onto the side hook and the top
hook located near the vehicle belt path. Repeat for the
other side.
2
Tuck the fabric into the groove gently around the
Child Restraint. Repeat for the other side. Hook BOTH
elastic straps onto the back of the Child Restraint.
3Slide the Armrest Fabric onto the armrest then snap
the Armrest Fabric to the Backrest Seat Pad. Repeat this
step for the other Armrest.
4
SOFTGOODS INSTALLATION:
Push the metal bar through slot on top of the Child Restraint seat and pull through the other side. Turn the metal bar
so that it lays flat on the bottom of the seat.
NEVER use Child Restraint without the Crotch Strap installed.
19
CROTCH STRAP INSTALLATION:

Tuck the fabric into the groove at the top of the
headrest. Push down gently on both of the plastic tabs at
the top of the Headrest until they snap into the grooves.
7With the Headrest in the highest position, hook the
elastic strap onto the BACK of the Headrest. Repeat this
step for the other elastic strap.
8
Hook the Armrest fabric loop onto the side hook
located near the vehicle belt path. Repeat this step for the
other side. TIP: To Assist in the attachment of the Armrest
fabric, push back on the fabric while hooking the loop.
5Place the Headrest Fabric Pad
onto the Headrest.
6
Place the Seat Bottom Fabric onto the Child Restraint
and pull fabric around the Harness Adjuster Strap Cover.
Then pull the Crotch Strap UP through the fabric and pull
the FABRIC down and around the front and sides of the seat.
9
5
Lift up on the Latch Storage Compartment door,
wrap both elastic straps on the Seat Bottom Pad around
each end of the Latch Storage Compartment door, as
shown. Close the Compartment door.
10

To attach the both Waist Belt pads, wrap one of the
pads around the Harness Waist Strap and attach the hook
and loop fasteners, repeat for the other Waist Belt pad.
16
Replace the Crotch Strap Pad by sliding the Harness
Buckle up through the Crotch Strap Pad. Then push the fabric
Tab through the slot on the FRONT of the Harness Buckle.
Then pull the Tab out of the BACK to secure it.
14
Re-attach Shoulder Pad by folding the hook and loop
Tab over the Harness Strap. Secure both hook and loop
sides together. Repeat for the other Shoulder Pad and
make sure they are oriented, as shown.
15
Match the “R” and “L” Cup Holders to the Child
Restraint, and insert the Cup Holder. Make sure the Lip fits
behind the groove and it clicks into place. Repeat this step
for the other Cup Holder.
11
RL
R
R
LIP
Re-attach the Seat Back Pad by zipping the pad at the
top of the headrest. Then attach both hook and loop tabs to
the underside of the Headrest fabric below the pad.
13
Re-attach the Seat Bottom Pad, thread the crotch
strap through the correct opening in the pad. Then zip the
pad at the back and front of the Seat Bottom Pad.
12
6