For your child’s safety, please read these instructions and keep for future reference.
WARNING
The Electronic Module requires 3 AA 1.5 volt batteries.
Batteries not included. Batteries must only be fitted by
an adult. Always keep batteries and tools out of reach of
children.
• Always remove exhausted batteries from the product to
avoid damage by possible battery leakage.
• Always remove batteries when the product is not going to
be used for long periods of time.
• It is recommended to use alkaline batteries of the same type
in this product.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(ni-cad) batteries. Do not mix old and new batteries.
• Always dispose of batteries properly.
• Do not short circuit battery terminals.
Clip-On
Electronic Module
Owner's Manual
If you have any questions or comments about this product,
or are missing any of the parts, please contact us in one of
the following ways:
(877)-424-4226
1826 William Penn Way
Lancaster, PA 17601
www.chiccousa.com
For More Information
Removing and Inserting Batteries
•
To prevent damage to the electronics, do not submerge the
product in water. Only use a soft damp cloth to clean the
product.
•
Protect the product against heat, dust, sand, and water.
Cleaning
IS0182E_01 ©2019 Artsana USA, INC. 07/19
This Electronic Module is not a toy and is not intended to be grasped by the child. DO NOT use
the Electronic Module unless it is attached to the side of the bassinet. Always follow all bassinet
warnings and instructions
.
• To prevent the risk of strangulation:
Do not attach strings or straps to the product.
• Remove and discard all packaging and packaging fasteners before using this product.
• Do not use the product if any components are broken or missing.
• Before each use, ensure that the product and all its components are not damaged. If damaged or broken,
immediately discard the Electronic Module.
• Do not use accessories or replacement parts other than those approved by Chicco.
• This product requires adult assembly.
FCC Information
Caution: changes or modifications not expressly approved
by the part responsible for compliance could void the user’s
authority to operate the equipment.
NOTE:This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or experienced radio/TV technician for
help.
