Child Craft FOREVER Eclectic Hampton F39011 User manual

1
AB20324B
Assembled as Crib (Style May Vary) Assembled as Toddler Bed (Style May Vary)
ASSEMBLY ASSISTANCE
IMPORTANT: Retain for future reference and
read carefully.
Foundations strives for the highest quality in our
products but occasionally a missing part or problem
can occur during assembly.
If any parts are missing or broken or you need
assistance with assembly, DO NOT return the
product to your dealer. Go to our website at
www.childcraftbaby.com or call Foundations
for assistance at 1-877-716-2757 (U.S. Only) or
1-330-722-5033 (Monday through Friday, 9:00
a.m.– 4:00 p.m. Eastern Time). Please have the
model number and manufacture date available
when you call or write us at:
Foundations, 5216 Portside Dr., Medina, OH 44256
KEEP INSTRUCTIONS
FOR FUTURE USE .
FOR CUSTOMER SERVICE CALL
1-877-716-2757
(outside of U.S. 330-722-5033). DO NOT CALL
RETAILER OR RESELLER FOR SERVICE
AS THEY ARE NOT AUTHORIZED TO
RESOLVE ANY SERVICE ISSUES.
FOR WARRANTY AND FEDERAL SAFETY STANDARD
COMPLIANCE CERTIFICATES, PLEASE VISIT OUR
WEBSITE AT
www.childcraftbaby.com
Record the information for your product here:
Model number:
Manufacture date:
PO number:
• Adult assembly required.
• Read all instructions BEFORE assembly and USE
of product.
• Unpack carton, remove packing materials,
including polybag. Identify and check all parts.
ASSEMBLY INSTRUCTIONS
THIS IS THE ASSEMBLY INSTRUCTIONS
FOR CRIBS SOLD IN THE
UNITED STATES
Foundations Worldwide, Inc.
5216 Portside Dr.,
Medina, OH 44256 USA
PH: 1 330.722.5033
FAX: [phone]
www.childcraftbaby.com
Hampton Flat-Top Crib
Model Covered:F39011

2
A. Head Board Assembly
B. Foot Board Assembly
C. Side Assembly Right
D. Side Assembly Left
E. Bottom Foot Board Assembly
F. Head Board Leg Assembly Left
G. Head Board Leg Assembly Right
H. Foot Board Leg Assembly Left
I. Foot Board Leg Assembly Right
J. Spring
K. Allen head Bolt 6mm x 80mm
L. Allen head Bolt 6mm x 55mm
M. Allen head Bolt 6mm x 12mm
N. Allen head Bolt 6mm x 45mm
P. Allen head Bolt 6mm x 17mm
Q. Joint Connector Nut
R. Connector nut
S. Steel Pin
T. Dowel 8mm x 30mm
U. Allen Wrench
Hardware Package
AB20287_G4
R x 4
K x 8
L x 2 M x 4
N x 12 P x 8
Q x 8
U x 2
S x 1
T x 4
Crib Parts
PARTS LIST BASIC CRIB
Part Description Part Number Quantity
PREPARATION
Carefully remove and lay out all hardware and parts.
Check quantities and match the parts list.
Construct Crib on an even at oor.
Note: during the assembly process whenever
using screws or bolts, check each with the parts list
by letter and size identication. Place each screw
or bolt on the diagram of the item which is sketched
actual size. Be sure to use the proper size specied
in the assembly directions. If any parts are missing
or broken or you need assistance with assembly
DO NOT return your product to the dealer.
Please identify the crib by the model number
identication stamped on the inside face of the Side
Assembly Right and Side Assembly Left when you
call or write to Foundations. Make note of all
identification numbers and include this information
with your request.
The Allen Head Bolts (M and P) have a friction
enhancing patch on the thread which may cause
resistance during tightening.
DO NOT Substitute Parts!
SUGGESTED TOOLS
#2 Medium Straight Screwdriver
AB20287_G3
AB
CD
E
J
FG
HI
1
1
1
1
1
1
1
1
1
1
8
2
4
12
8
8
4
1
4
2
22303192
22302855
22302865
22302916
22303139
22302850
22302849
22302868
22302869
11200975
11200971
11200984
11201000
11200974
11200976
11200970
11201001
11201002
11200969
11200978
(Style May Vary)

3
STEP 1
A
G
T
T
K
F
Q
QK
R
M
M
AB20287_G5
A x 1
G x 1
F x 1
K x 4
R x 4
M x 4
T x 2
Q x 2
STEP 2
B
E
Q
T
T
S
H
K
L
K
I
Q
Q
L
K
K
AB20287_G6
Q
L
K
H
B
E
T
B x 1
H x 1
I x 1
E x 1
K x 4
Q x 4
L x 2
T x 2
S x 1

4
STEP 3
STEP 4
AB20287_G8
A
N
C
C x 1
N x 3
D
AB20287_G7
A
N
D x 1
N x 3

5
AB20287_G9
N
B
N
N x 6
STEP 5
AB20287_G10
1
J
2
3
P
PJ x 1
P x 4
STEP 6

6
TODDLER BED / GUARD RAIL STEP 1
AB20287_G12
B
K
Qx2
L
K
L
Finishing Touches
Place a purchased full sized mattress on the spring.
After completing the crib assembly, and after
making yourself aware of WARNINGS, CAUTIONS,
CLEANING,STORAGE,USE and MAINTENANCE
of crib on pages 9 and 10, store the assembly
directions in the pouch which was pre-attached to
the spring. For future referral to assembly directions
you will only need to remove them from the pouch.
We caution you not to store excess hardware in
pouch as this would be a danger to child if retrieved
by him/her.
AB20287_G11

7
GUARD RAIL STEP 2
AB20287_GGR
Assembly bolts come with guard rail kit available from your Child Craft dealer.

8
WARNING
WARNING:INFANTS HAVE DIED IN TODDLER BEDS FROM
ENTRAPMENT. Openings in and between bed parts can entrap head and neck of a
small child. NEVER use bed with children younger than 15 months. ALWAYS follow
assembly instructions.
WARNING:STRANGULATION HAZARD: NEVER place bed near windows
where cords from blinds or drapes may strangle a child. NEVER suspend strings
over bed. NEVER place items with a string, cord or ribbon, such as hood strings or
pacifier cords, around a child’s neck. These items may catch on bed parts.
CAUTION:ENTRAPMENT HAZARD: To avoid dangerous gaps, any
mattress used in this bed shall be a full-sized crib mattress at least 51 5/8 in. (1310
mm) in length, 27 1/4 in. (690 mm) in width, and 4 in. (100 mm) in thickness.
• The users maximum weight shall not be greater than 50 lbs. (22.7 kg).
• Mattress MUST be moved into lowest position for proper positioning.
•This crib contains all components necessary to convert to a toddler bed. However,
a guardrail may be available for purchase to provide additional security. Contact
Foundations® for assistance. Refer to maintenance section for contact
information.
WARNING
WARNING
WARNING
WARNINGS (For Toddler Bed)
FULL SIZE BED CONFIGURATION
Guard Rail and Full Bed Options are complete kits that can be purchased separately
from your Child Craft dealer.
AB20287_GFB
P
Px8
Rx2
Rx2
P x 8
R x 4

9
Maintenance Cleaning and Storage
MAINTENANCE:
Upon completion of the assembly, check to make sure all screws, bolts and connectors are tightened and
secure.
Periodically check crib for damaged hardware, loose joints, missing parts or sharp edges before and after
assembly and frequently during use.
DO NOT use crib if any parts are missing or broken.
If any parts are missing, broken or you need assistance DO NOT return crib to your dealer.
Call Foundations at 330.722.5033 and include model identication numbers recorded on page 1.
DO NOT substitute parts.
CLEANING:
Mix a mild solution of gentle dishwashing soap and water, apply to surface using a clean cloth lightly
dampened in the solution. Rinse well with clear water using a soft clean cloth, then dry all surfaces with a
soft dry cloth.
DO NOT use abrasive cleaners or any cleaners with harsh chemicals that would contact a child’s
skin, scouring pads, steel wool or coarse rags. This crib should be treated the same as any ne
furniture.
STORAGE:
When storing crib use caution as extreme temperature or humidity changes could be harmful.
Use caution when a vaporizer is in use. Always aim vapor stream away from crib as well as away
from any wood furniture item.
After completing the assembly the user is advised to read and be aware of
ALL WARNINGS, CAUTIONS, CLEANING, STORAGE USE AND MAINTENANCE notices in these
directions and printed on the storage pouch on the crib spring. A printed pouch is attached to the
crib spring for the permanent storage of the assembly directions. Please place the complete set of
assembly directions into the pouch for future referral. We caution the user to not place excess
hardware in the pouches as it could present danger to the child if retrieved.
CAUTION
•ANY MATTRESS USED IN THIS CRIB SHALL BE AT LEAST
27 1/4 BY 51 5/8 IN. WITH A THICKNESS NOT EXCEEDING
6 IN. IF YOUR CRIB IS DESIGNED TO CONVERT TO A
TODDLER BED, THE MATTRESS MUST BE AT LEAST 4 IN.
(100 MM ) THICK.
• UPON COMPLETION OF ASSEMBLY BE SURE ALL SCREWS, BOLTS AND
FASTENING DEVICES HAVE BEEN TIGHTENED SECURELY. A FREQUENT CHECK
SHOULD BE MADE OF ALL SCREWS, BOLTS AND FASTENING DEVICES AND
TIGHTEN IF NEEDED.

10
• Read all instructions before assembling crib. Keep instructions for future use. A
pouch is attached to the crib for permanent storage of the instructional literature.
• To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on
their backs to sleep, unless otherwise advised by your physician.
• Strings can cause strangulation! DO NOT place items with a string around a child’s
neck, such as hood strings or pacifier cords. DO NOT suspend strings over a crib
or attach strings to toys.
• To help prevent strangulation, tighten all fasteners. A child can trap parts of the body or clothing
on loose fasteners.
• DO NOT place crib near window where cords from blinds or drapes may strangle a child.
•When child is able to pull to standing position, set mattress to lowest position and remove
bumper pads, large toys and other objects that could serve as steps for climbing out.
• Stop using crib when child begins to climb out or reaches the height of 35 in. (89 cm).
• After raising side, make sure latches are secure (if your unit has a movable side).
• DO NOT leave child in crib with side lowered. Be sure side is in raised and locked position
whenever child is in crib (if your crib has a moveable side).
• Check this product for damaged hardware, loose joints, loose bolts or other fasteners, missing
parts or sharp edges before and after assembly and frequently during use. Securely tighten bolts
and other fasteners. DO NOT use the crib if any parts are missing, damaged or broken. If any
parts are missing or broken or you need assistance with assembly, DO NOT return the product to
your dealer. Call Foundations for assistance at 1 877.716.2757 (U.S. Only) or +1 330.722.5033 for
replacement parts and instructional literature if needed. Include model identication numbers
recorded on page 1 with your request. DO NOT substitute parts.
• Replace teething rail(s) if damaged, cracked or loose (if equipped with teething rails).
• If renishing use a non-toxic nish specied for children’s products.
• Follow warnings on all products in a crib.
• NEVER use plastic shipping bags or other plastic lm as mattress covers because they can
cause su󰀨ocation.
• Infants can su󰀨ocate in gaps between crib sides and a mattress that is too small.
• DO NOT use a water mattress with this crib.
• When disassembling this crib, DO NOT remove any item attached with wood screws.
Meets CPSC
Safety Requirements
5216 Portside Dr.
Medina,Ohio 44256 USA
Telephone: [phone]
Fax: [phone]
www.childcraftbaby.com
WARNING
WARNING: Infants can su󰀨ocate on soft bedding. NEVER add a pillow
or comforter. NEVER place additional padding under an infant.
FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT
IN SERIOUS INJURY OR DEATH.
WARNING