4.
5.
6.
Yellow RCA jack for video 1 input
White RCA jack for audio input
Yellow RCA jack for video 2 inpul
OSD ln PC mode.
OSD ln AV moder
You mn press " A"/' V " on the unit or on lhe remote controller to select
the items: l} coloB & ADJUS, m MENU K EDrn B voLurvrE ),
and onfirm buy pressing " 4"f 2" on the unit or on the remote controller,
then push " <"f 2" again to adjust the items. Push "ittu" to exit the OSD
after your adjust.
o Descrlptlon of OSD:
ln PC moder
B (otct,
\
I
II
I
ptctuE t[ (VGA cable)
'l . Black g-pin jack connect g-pin plug of picture 3
2. USB end connect the USB port of computer for touch screen function.
3. 1 s-pin VGA signal input end connect VGA port of the computer
2. Gonnec-tlon
Put the SKS input end ofAV cable picture 3 into theAV inputjack ofthe monitor,
the otherjack ofA / cable should be mnnected with related signal as follows .
1 . Black g-pin plug of picture 3 is connected to the g-pin jack of picture 4 (note
the arrowhead),the VGA signal input end of picture 4 will be connected to
the VGA port at the back of computer ,then tighten the screws . The USB
end connects the USB port of the computer for touch screen function.
2. Yellow RCAjack connect video signal 1
3. Yellow RCAjack connect video signal 2
4. White RCA jack conngct audio signal
5. Blackjack connect DC12v power
6. When you us6 th6 unit, please adopt matched DC adapter, if not, pleass
note that tho pow6r consumption should be less or equal to 10w.
. Manual oporatlon
After connscting power, the unit will be in staridby state fed light) . Press " {}'
on the unit or on the remote controller, the buttons of tho unit will blue light, at
that time th€ unit begins to work. Press the same button again the unit will
return to its standby state (Note the blue button will black out in 5 or 6 seconds
soon after you tum ofi unit.). Push 'PC/AV' on the unit or AV/18 on the remote
controllor to switch between AV and PC.
Aft€r 6nt6r into'Coloi' item of OSD, use " A" / " V " to select and then
