Christopher Knight Home VIRGINIA User manual

Assembly instructions
Warnings: You must read this before you proceed.
VIRGINIA CAST BENCH
CAUTION : This bench is NOT a TOY. Keep your child / children at bay in
the process of assembly.
1 OF 5

NO. Picture Description QTY
A Backrest Panel 1
B Chair Seat Panel 1
C
Right Arm with pre-attached Leg
Levellers
1
D
Left Arm with pre-attached Leg
Levellers.
1
E Studs(8*30mm) 9
Washers(8mm) 9
Spring Washers(8mm) 9
Nuts(8mm) 9
GCaps 9
H Spanner 1
I Screwdriver 1
F
Hard ware
Assembly Preparation
Before Beginning Assembly:
Parts list
2 OF 5

Place the Left Arm flat on the ground.
Fix the Studs (E) to the contact points on the Right arm (C) using the
Screwdriver (I).
Then attach the Chair Seat Panel (B) and Backrest Panel(A) to the Right arm
(C) using Caps(G) , Nuts, Spring Washers and Washers(F) with the
Spanner(H).
DO NOT OVERTIGHTEN, yet.
Unpack and place all parts on a clean soft surface.
Assembly Step
3 OF 5

Turn the Bench rightside.
Adjust the pre-installed Rubber Caps until the bench is level with the ground.
Now, proceed to FULLY TIGHTEN all screws and bolts.
Your Bench is ready for use.
Fix the Studs (E) to the contact points on the Left arm (D) using the
Screwdriver (I).
Attach the Left arm(D) to the Chair Seat Panel(B) using Caps(G) , Nuts,
Spring Washers and Washers(F).
Then to the Backrest Panel(A) using Caps(G) , Nuts, Spring Washers and
Washers(F).
Hold all parts tightly during the assembly process,2 persons may be needed
to execute this action.
DO NOT OVERTIGHTEN, yet.
4 OF 5

Care & Maintenance
5 OF 5