CIS CRS354-48P User manual

CIS—CRS354-48P
Welcome
Thank you for choosing CIS! This quick setup guide will assist you with getting your CIS switch up and
running. For more detailed conguration, please check the user manuals located on our website. If you
have any questions, please do not hesitate to contact our support team.
The CIS-CRS354-54P switch is equipped with 48 Gigabit Ethernet ports (with Auto MDI/X), 4 SFP+ ports, 2
QSFP+ ports, and an RJ45 serial port that is disabled by default. The top LEDs will show green when using
low voltage PoE, and red when using high voltage PoE.
Powering the Switch
Connect the included IEC power cable to the rear of the switch.
Connect your router or upstream switch to any of the Ethernet ports, or use an SFP or SFP+ connection if
your device supports it. Connect your devices to the remaining ports
Switch Setup
Router or Switch
Computers/Devices
Routers/Switches
with SFP Ports

CIS—CRS354-48P
Conguring the Switch
The CIS-CRS354-54P is precongured to work without any initial conguration. You can congure the PoE,
VLANs, and static IP by accessing the web interface.
integration
10.100.1.149
2. Open a web browser and navigate to the IP address of your switch. The default username is cis and the
default password is integration.
1. Log into your router. Access the DHCP leases. If you’re using a CIS router, select IP from the left toolbar,
DHCP Server, then click the Leases tab. Locate the switch in the leases, then make note of it’s current IP
address.
CIS-CRS354-54P

CIS—CRS354-48P
PoE Output
The CIS-CRS354-54P provides PoE output on all Ethernet ports. The output voltage is selected automati-
cally based on the voltage the connected device requires.
• The switch can power passive PoE devices, and 802.3af/at compliant devices.
• The total PoE limit is 700w.
• High voltage output supports 30W per port, low voltage output supports 26W per port.
Reset Button
Hold this button during while the device is powered off, then apply power. Keep holding until the USR LED
light starts ashing, (5 seconds) then release the button to reset to the default CIS conguration. You can
use this procedure if you have forgotten the password to access the device, or simply wish to return the
unit to its default conguration state.
Warranty Information
Custom Integration Solutions™ products have a 2-Year Limited Warranty. This warranty includes parts and
labor repairs on all components found to be defective in material or workmanship under normal condi-
tions of use. This warranty shall not apply to products that have been abused, modied, or disassembled.
Products to be repaired under this warranty must be returned to Custom Integration Solutions™ or a des-
ignated service center with prior notication and an assigned return authorization (RA) number.
Contact Information Web: www.custom-integration-solutions.com
Phone: Technical Support - [phone]
The CIS-CRS354-54P is in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EC.