Clarke CM145 User manual
Page - 1
Thank you for purchasing this CLARKE 150mm
Digital Caliper.
Please read this instruction leaflet thoroughly
and follow the instructions carefully, to ensure
that the instrument will give you long and
satisfactory service.
Please keep these instructions in a safe place
for future reference.
Waste electrical products should not be
disposed of with household waste. Please
dispose of at your local recycling facility.
USER INSTRUCTIONS
GC0113
150mm
DIGITAL CALIPER
Model No: CM145
Part No: 4500360
Page - 2
This CLARKE product is guaranteed against
faulty manufacture for a period of 12 months
from the date of purchase.
Please keep your receipt as proof of purchase.
This guarantee is invalid if the product is found
to have been abused or tampered with in any
way, or not used for the purpose for which is
was intended.
Faulty goods should be returned to their place
of purchase, no product can be returned to us
without prior permission.
This guarantee does not effect your statutory
rights.
Measuring Range: ............... 0mm - 150mm
Measuring Scale: ................ 0.01mm/0.005”
Measuring Tolerances:
0mm - 150mm: ......... 0.03mm
Battery Type & Voltage: ..... Alkaline Cell
(LR44) 1.55 Volt
SPECIFICATIONS
GUARANTEE
SAFETY PRECAUTIONS
• Keep the body of the caliper clean at
all times, do not use alcohol or other
corrosive chemicals as they could
damage the internal electronics
.
• Prevent accidental damage to the
caliper by storing in its case when not in
use.
• DO NOT immerse the caliper in liquid or
allow liquid to enter the slide.
Page - 3
•Loosen the slide clamp screw.
•
Press the ON button to switch the calipers
on, select the required measuring unit by
pressing the inch/mm mode switch.
• Apply pressure to the thumb roller and
close the caliper jaws, press the ‘ZERO’
button to zero the display.
GENERAL VIEW
SETUP AND OPERATION
Page - 4
APPLICATIONS
Measurement of
internal diameter.
Measurement of
external diameter.
Page - 5
Measurement of
depth.
Measurement of
steps.
Page - 6
When the display constantly flashes
the battery requires
replacement.
Slide off the battery compartment
cover and insert a new battery with
the positive (+) side facing up.
BATTERY REPLACEMENT
Low battery - Replace
battery.
Display flashes
constantly.
Display fails to
change when
slider is moved.
Display fails to
function.
FAULT: CAUSE/SOLUTION:
TROUBLESHOOTING
Electronic fault - Remove
battery & re-insert after 30
seconds.
Battery flat or in poor
contact - Re-insert or
replace battery.
Dirty sensor - Clean
caliper thoroughly with
compressed air.
Measuring
becomes less
accurate.
Page - 7
For spare parts and servicing,
please contact your nearest
dealer, or CLARKE International
on:
020 8988 7400
or email:
CLARKE International,
Hemnall Street, Epping, Essex, CM16 4LG
Please Note that details and specifications herein,
are correct of time of going to print.
However CLARKE International reserve the right to
change specifications at any time without prior
notice.
Copyright CLARKE International All rights Reserved
2006.
Page - 8
Other manuals for CM145
2
Table of contents
Other Clarke Measuring Instrument manuals
