Clarke CM265 User manual

0207
300mm DIGITAL CALIPER
300mm DIGITAL CALIPER
Model No: CM265 Part No: 4500365
Thank you for purchasing this CLARKE 300mm Digital Caliper.
Please read this instruction leaflet thoroughly and follow the instructions carefully, to ensure that the
300mm Digital Caliper will give you long and satisfactory service.
Please keep these instructions in a safe place for future reference.
CLARKE GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase.
Please keep your receipt as proof of purchase.
This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for
the purpose for which is was intended.
Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission.
This guarantee does not effect your statutory rights.
TECHNICAL SPECIFICATION
Product Specification:
Measuring Range: ................................................................................................................................ 0mm - 306.97mm
Measuring Scale: ....................................................................................................................................0.01mm/0.0005”
Measuring Tolerances: ........................................................... (0mm - 200mm: 0.03mm) (200mm - 300mm: 0.04mm)
Battery Type & Voltage: .................................................................................................... Alkaline Cell (LR44) 1.55 Volt
Please Note that details and specifications herein, are correct of time of going to print.
However CLARKE International reserve the right to change specifications at any time without prior notice.
Copyright CLARKE International All rights Reserved 2006.
Waste electrical products should not be disposed of with household waste. Please dispose of at your local recycling facility.
USER INSTRUCTIONS
GENERAL PRECAUTIONS
• Keep the body of the caliper clean at all times, do not use alcohol or other corrosive chemicals as they could
damage the internal electronics .
• Prevent accidental damage to the caliper by storing in its case when not in use.
• DO NOT immerse the caliper in liquid or allow liquid to enter the slide.

SETUP AND OPERATION
•Loosen the slide clamp screw.
• Press the ON button to switch the calipers on, select the required measuring unit by pressing the inch/mm mode switch.
• Apply pressure to the thumb roller and close the caliper jaws, press the ‘ZERO’ button to zero the display.
MEASURING APPLICATIONS:
Measurement of
external diameter.
Measurement of
internal diameter.
Measurement
of steps.
Measurement
of depth.
GENERAL VIEW
BATTERY REPLACEMENT
When the display constantly flashes the battery requires
replacement. Slide off the battery compartment cover
and insert a new battery with the positive (+) side
facing up.
For spare parts and servicing, please contact your nearest dealer, or CLARKE International on:
020 8988 7400 or email: [email protected]
[email protected]
CLARKE International, Hemnall Street, Epping, Essex, CM16 4LG
Low battery - Replace battery.
Electronic fault - Remove battery & re-insert after 30 seconds.
Battery flat or in poor contact - Re-insert or replace battery.
Dirty sensor - Clean caliper thoroughly with compressed air.
LCD Display
Inside Measuring Faces
Depth Measuring Blade
Step Measuring Faces
Beam
Main Scale
Battery Compartment Cover
Manufacturer Access Cover (Keep Closed)
Slide Clamp Screw
Thumb Roller
Power OFF Switch
ON / Display ‘Zero’ Switch
Inch / mm Mode Switch
Outside Measuring Faces
TROUBLE SHOOTING:
FAULT: CAUSE/SOLUTION:
Display flashes constantly.
Display fails to change when slider is moved.
Display fails to function.
Measuring becomes less accurate.