Clarke CSP420 User manual

ASSEMBLY INSTRUCTIONS
Model No:CSP420
Part No:6600530
GC0310
4-TIER SHELVING RACK

2
INTRODUCTION
Thank you for purchasing this CLARKE Shelving Rack.
Before attempting to use the product, it is essential that you read this manual
thoroughly and carefully follow all instructions given. In doing so you will
ensure the safety of yourself and that of others around you, and you can also
look forward to the product giving you long and satisfactory service.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt which will be
required as proof of purchase.
This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for its intended purpose.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission. This guarantee does not effect
your statutory rights.
ENVIRONMENTAL PROTECTION
Do not dispose of this product with general household waste. All tools,
accessories and packaging should be sorted, taken to a recycling
centre and disposed of appropriately.
SPECIFICATION & INVENTORY
Dimensions (l x w x h) 610 x 305 x 1330 mm
Product Weight 4.2 kg
Max Load per Shelf 20 kg (evenly distributed)
When unpacking, check for damage and/or shortages etc. Any found
should be reported to your CLARKE dealer where the product was
purchased. This shelving rack should include the following:
4 x Feet 12 x Supporting Legs 4 x Top Inserts
4 x Shelf Panels 1 x Instruction Manual (this document)
Please keep these instructions in a safe place for future reference.

3
GENERAL SAFETY GUIDELINES
1. ALWAYS maintain this product in good condition for greater safety.
2. NEVER exceed the maximum recommended load for this product.
3. NEVER use this product if damaged.
4. ALWAYS load small, stable items on the top shelves, heavier and bulky
items should be stored on the lower shelves.
Caution: This product is not intended to come into contact with cleaning
agents/corrosive chemicals or sources of heat e.g. naked flames etc.
ASSEMBLY TIPS
This CLARKE shelving rack requires no screws or fixings for assembly, providing
easy and rapid installation. Assemble the product on a strong, level surface
rather than a soft surface.
1. Take the feet and push them onto the underside of one of the shelves as
in Fig 1.
2. Insert the supporting legs, narrow end downwards through the shelf
corner pockets and into the feet from the upper side of the shelf, trapping
the shelf between the foot and leg.
3. Turn the assembly over the right way up and add the next shelf panel and
continue until all the legs and shelf panels are assembled. Ensure the
supporting legs are connected with the narrow end downwards to lock
the parts together.
4. Finally, insert the top inserts into the holes in the top shelf as shown in Fig 2.
Fig 2
Fig 1