Clarus BALANCE User manual

BALANCE
Installation Instructions

PROVIDED HARDWARE
(QUANTITY)
1. BT-A-SB-1 (10)
2. BT-A-IG-1 (2)
3. Net Assembly (1)
4. Glass Top (1)
5. BT-A-FR Assembly (1)
6. BT-A-SO-1 (6)
7. BT-A-OG-1 (2)
8. BT-A-CR-1 (1)
9. BT-W-SP-1 (10)
10. BT-W-SD-1 (2)
11. 3-8 16 x 3-8 Set Screw (20)
12. 1-4 20 x 1-2 bolt (10)
13. 1-4 20 x 3-4 Bolt (20)
14. 5-16 18 x 1 Set Screw (4)
15. 3-8 16 x 1 Bolt (6)
16. 3-8 16 x 2 1-2 Bolt (6)
11.
12.
13.
14.
15.
16.
1
2
3 4
5
6
7
8
910

STEP 2 • Mount frame braces and glass frame. Fig. B
Fig. B
3/8” – 16 x 1” 6x
3/8” – 16 x 2 1/2” 6x
BT-A-SO-1
ASSEMBLY
STEP 1
• Tighten as last step of assembly, before laying glass on
top of frame.
• Assemble frame legs and arms together
(Note order of
BT-W-SP-1 parts).
Fig. A
Fig. A

STEP 4 • Aach table arms to center support bar. Fig. D
Fig. D
1/4” – 20 x 1/2” 20x
STEP 3 • Aach table arms to table frame. Fig. C
Fig. C
3/8” – 16 x 3/16” 20x
1/4” – 20 x 3/4” 20x

STEP 6
STEP 7
• Mount net arms to each table leg. Fig. F
• Feed cables through turnbuckles.
Fig. F
5/16” – 18 x 1” Set Screw 4x
1
2
STEP 5 • Lower Clarus glass onto Balance table frame. Fig. E
Fig. E

STEP 9 • Install turnbuckles, with ball end of cable, to set screws,
leaving roughly 1/8” of threads exposed. Fig. H
STEP 8 • Install net rods at end of net, feed cable through net rod
and net. Fig. G
Fig. G
Fig. H
32 x 3/16” 4x
Approx 1/8”

STEP 12
STEP 13
STEP 14
• Insert cable into turnbuckle and tighten set screw.
• Tighten turnbuckles.
• Center net on cables, tighten net rod set screws on one
side, pull other side taught, and tighten net rod set screws.
STEP 10
STEP 11
• Install turnbuckles on other side, leaving 1/8” of threads.
• Pull cable tight by hand, mark and cut cable approx. 3/8”
past set screws.
clarus.com | 888.813.7414 © 2018 Clarus. All rights reserved.