Classic Exhibits VISIONARY DESIGNS MOD-1353 Manual

© 2023
Order #XXXXX
Locked layer contains
placeholder marks.
Completed Assembly
*
*
Stand
2
1
Rotate clamshell
to turn iPad from portrait
to landscape orientation.
Foam Lining
Removed
Home Button Shield
Optional Cover for Home Button
1) Remove foam lining from inside bottom of
clamshell.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening.
NOTE: This is a permanent fix and can’t be
easily removed.
Connector
Literature Holder Attachment
Locks
Literature
Holder
Attach angled end of connector to
literature holder. Attach flat end of
connector to post. Tighten
locks to secure.
*
Post
Cord Management for iPad
Attach iPad cord to supplied USB extension
cord. Feed USB cord through top hole of
post, then out bottom hole of post.
connect to power.
Cord
Access
iPad
Lock Lock
Clamshell
Hex
Nuts
3
Infill
Clamshell
Literature
Holder
Literature
Holder
Item
1
2
3
Qty.
1
1
1
Description
Base Plate
10” Z72 Horizontal Extrusion
Mount Plate
Steps:
1) Slide Infill into stand verticals as shown.
2) Attach horizontal [2] between stand verticals.
3) Attach base plate [1] to stand verticals, using bolts.
4) Attach mount plate [3] to stand, using bolt
NOTE: Mount Plate must rotate to left and right before installing Clamshell.
5) Attach clamshell to mount plate [3], using hex nuts.
6) Insert iPad into clamshell then route cords. See Cord Management for iPad detail.
7) Attach literature holders to stand. See Literature Holder Attachment detail.
Cord Management
Route cord through conduit.
Attach conduit by pinching
the opening and inserting
into the groove of stand.
pinch
Cord
Stand
Conduit for cord management
MOD-1353 iPad Kiosk
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2023
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information

© 2023
Case 1 of 1
Order #XXXXX
Locked layer contains
placeholder marks.
Top View of Each Level
Setup Hardware
Literature Holders
Level 1
(Bottom level)
Level 2
Clamshell
Base Plate [1]
Assembled Stand
Case Packing