Clear One DIALOG 20 User manual

Quick-Start Guide
QSG-0138-001v1_DIALOG_Transmitters_2021_09_21
DIALOG®20 Wireless Transmitters

DIALOG 20 Wireless Transmitters
QSG-0138-001v1_DIALOG_Transmitters_2021_09_21
Quick-Start Guide
Contents:
Setting up the system ............................................................................................................................ 3
Box Contents ................................................................................................................................ 3
Set Up ........................................................................................................................................... 3
Syncing the Transmitters with the Receiver ........................................................................................ 4
Reading the Transmitter LCD................................................................................................................ 4
Reading Transmitter LED ...................................................................................................................... 5
2

DIALOG 20 Wireless Transmitters
QSG-0138-001v1_DIALOG_Transmitters_2021_09_21
Quick-Start Guide
Setting Up ClearOne DIALOG 20 Wireless Transmitters:
Packing List: Inspect your shipment carefully and verify contents. If the shipment shows signs
of damage, retain original boxes and packing material for inspection by the carrier, and contact them
immediately. ClearOne is not responsible for product damage incurred during shipment.
The contents of each transmitter package are listed below. The transmitters in your system will
depend on the transmitters purchased for your DIALOG Wireless System.
DIALOG 20 Podium Transmitter:
(Qty. 1) Podium Base Unit with Battery Cassette
(Qty. 4) Rechargeable, AA, NiMH batteries
(Qty. 1) Gooseneck Microphone
(Qty. 1) Wind Screen
DIALOG 20 Handheld Transmitter:
(Qty. 1) .... Handheld Microphone
(Qty. 2) .... Rechargeable, AA, NiMH batteries
(Qty. 1) .... Mic-stand Clip
DIALOG 20 Boundary Transmitter:
(Qty. 1) .... Boundary Microphone
(Qty. 2) .... Rechargeable, AA, NiMH batteries
DIALOG 20 Belt Pack Transmitter:
(Qty. 1) .... Beltpack Base Unit
(Qty. 2) .... Rechargeable, AA, NiMH batteries
(Qty. 1) .... Beltpack Antenna
3
Box Contents:
DIALOG 20 Wireless Transmitters are compatable with DIALOG 10 and DIALOG 20 Receivers.
1. Charge the Transmitters:
Transmitters include rechargeable batteries. Install the
batteries, connect the USB-A to USB-Micro cable to the
transmitter and plug it into a USB power source to charge
the batteries (12 hrs is required for a full charge).
USB-A to USB-Micro Cable
ON/OFF
IR USB
OR
Set Up:
Refer to the DIALOG 10 Receiver QSG for instructions on setting up the receiver.

DIALOG 20 Wireless Transmitters
QSG-0138-001v1_DIALOG_Transmitters_2021_09_21
Quick-Start Guide
Syncing Transmitters with Receiver:
1. Simultaneously, press the two buttons on the bottom of the receiver module. ”SCANNING” shows
on the receiver’s display for 5 to 10 seconds followed by “SYNCING”.
a. To sync a Boundary Mic or Podium Mic:
While the receiver shows “SYNCING”, Press and hold the “Mute” button, power on the
transmitter and then release the “Mute” button.
b. To sync a Handheld or Beltpack:
While the receiver shows “SYNCING”, Press and hold the “Select” button, power on the
transmitter and then release the “Select” button.
Both the transmitter and receiver display will read “SYNC PASS” when the sync is successful.
2. Repeat the procedure if the receiver display shows “SYNC FAIL”.
3. Check the audio.
“SCANNING” will only be displayed if auto-scan is enabled.
4
Reading the Handheld Mic and Beltpack LCD:
Battery Life Runtime Counter
Audio Level
Battery Level and Charge Status
Editable Microphone ID Labeling (Up to 10 Characters)
Power Setting
Programmable Button Setting
RF Channel Assignment
BATTERY AUDIO
CH 1 ON-OFF 10 MW
04.6H LVL+20 DB
LCF
75 HZ
MIC-1 RM-4
Microphone Audio Settings

DIALOG 20 Wireless Transmitters
QSG-0138-001v1_DIALOG_Transmitters_2021_09_21
Quick-Start Guide
5
In Use and Charging Satus:
THE LCD SHOWS THE BATTERY LIFE AND CHARGING
STATUS (See pg. 4)
In Use:
l RED = AUDIO MUTED
l GREEN = AUDIO PASS
ll BLINK GREEN = SYNC
ll BLINK RED = LOW BAT
Charging Status:
l RED CHANGE TO AMBER = CHARGING
l GREEN = CHARGED
ll GREEN & RED BLINK = CHARGING ERROR
(RE-SEAT TRANSMITTER / CHECK BATTERIES)
Reading the Transmitter LED:
The Podium Gooseneck Battery
Cassette when charged in the dock:
Table-top Boundary Mic when
it is charged in the Dock:
The Handheld and Beltpack when in use,
charged via USB, or charged in the Dock:
Charging Dock is an optional accessory.
LED
Charging Status:
l RED = CHARGING
OFF = CHARGED
Gooseneck Podium Mic and Table-top
Boundary Mic in use, or when being
charged via USB:
LED
LED
LCD
LCD
Battery Power or USB Power:
Charging Status:
l RED = NOT CHARGED
l AMBER = CHARGING
lGREEN = CHARGED

DIALOG 20 Wireless Transmitters
QSG-0138-001v1_DIALOG_Transmitters_2021_09_21
Quick-Start Guide
Other product names may be registered trademarks of their respective owners who do not necessarily endorse ClearOne or ClearOne’s products. All rights reserved.
Information in this document subject to change without notice. © 2021 ClearOne. QSG-0138-001 ClearOne_DIALOG20_Transmitter_QuickStartGuide-V1.0 September 21, 2021
Headquarters
5225 Wiley Post Way
Suite 500
Salt Lake City, UT.
84116
US & Canada
Tel: [phone]
Toll Free: 800.945.7730
Fax: [phone]
International
Tel: [phone]
Email: [email protected]
Sales
Tel: [phone]
Email: [email protected]
Tech Support
Tel: [phone]
Email: [email protected]
Antenna Design
Tel: [phone]
Email: [email protected]