
OPERATING YOUR OSCILLATING VERTICAL QUARTZ HEATER
CAUTION: The EPS (thermocol) inside this front grill is for protection of the Quartz
Tube Heating Element during transportation.
Please remove the front grill by pulling the top portion to release the locks, remove
the thermocol packing and refix the front grill before use. Failure to do so
will cause the thermocol to burn and produce toxic fumes and will also damage
the heater.
1. In order to avoid overheating, do not cover the heater
2. Do not turn on the heater if the casing shows visible damage ( cracks / Breaks),
if the power cord is faulty or if any invisible defect is suspected (for instance, after a fall)
3. Only connect the heater if the voltage indicated on the rating label corresponds with the
mains voltage at your place.
4. Heater surfaces that radiate heat can become hotter than 60˚C
5. When in use, the power cord must not lie on the heater.
6. Be careful and do not use the heater in the immediate surroundings of a both, a shower
or swimming pool.
7. The heater must be placed in such a way that combustible objects cannot catch fire.
8. The heater must not be located immediately below a socket outlet.
9. The heater must be positioned away from towels, curtains and such likes, as there is
danger of overheating when it is coverd.The fresh air intake and the blowing out of warm
air musyt not be impeded.
10. For maintenance and after use, the heater must always be turned off, the plug must be
pulled out and the heater must be allowed to cool down.
11. The heater must not be stored outdoors.
12. The heater may only be cleaned with a dry cloth or with a slightly moist cloth. The electric
parts (switch, plug, heating element etc) must not get in touch with water.
13. The heater has hot and/or sparking parts inside. Do not use it in areas where gasoline,
1. Select the setting requried on the switch panel
i
ii
iii
750 watts - Select first switch
1500 watts - Select first & second switches
Oscillation - Select the third switch
SAFETY INSTRUCTIONS