ClimaRad Sensa Horizontal User manual

User Instructions ClimaRad Sensa Horizontal
(until 2016)and ClimaRad Sensa Vertical
A ClimaRad ventilation unit is a device that ensures an optimum air quality through ventilation and air filtration.
The unit also recovers heat, so as to minimise heat loss.
The ClimaRad Sensa consists of a ventilation unit with a cover. The ClimaRad Sensa Horizontal is positioned
horizontally and the ClimaRad Sensa Vertical is positioned vertically.
What is the purpose of a ClimaRad ventilation unit?
Sensa horizontal
Sensa vertical
The installer will have adjusted the settings of the ClimaRad to the room in which it is installed. That is why we
only explain the function keys you will need for daily use.
Control Panel Type I
SMART SENSOR CONTROL 10,5 8
luchtkwaliteit
snelheid
basisventilatie
filter vervuild
You can operate your with the on the side of theventilation unit control panel upper cover.
luchtkwaliteit
sensorgestuurd handbediening
INTELLIGENT CO + HUMIDITY CONTROL
2
1u 30" 8u
aan pauze maximum koele lucht
zz
z
basisventilatie
filter vervuild
snelheid
Control Panel Type II
Use of the ClimaRad ventilation unit
20 8.0011
outlet to
outside
CO sensor
2
Warmtewisselaar
supply of
outside air
supply of clean
and preheated
outside air
outlet for used
(polluted) air
Future comfort today

ClimaRad B.V. - Lübeckstraat 25 - 7575 EE - Oldenzaal - NL - [email protected] - www.climarad.co.uk - tel. [phone]
8
Press 4 seconds simultaneously
Press simultaneously
Press seconds simultaneously6
Other function keys
Messages Switch off
Basic ventilation. Ventilates the air for 15 minutes every hour, regardless of the air quality.
Starts when the button is pressed for 4 seconds. Repeat this when you want the basic
ventilation to end. You can use this function, for instance, if the room hasn't been used for
a few weeks and you want to increase the ventilation, such as after a holiday.
Pause. Will pause the ventilation for 1 hour. The valves will close. This ends as soon as you
start a different function. Use this function, for instance, to temporarily block out any
outside odours.
Maximum ventilation. Maximum ventilation for 30 minutes. This ends as soon as you start a
different function. Use this function to remove unpleasant odours, such as smoke or
cooking smells.
Ventilation with cooler outside air. Ventilates for 8 hours with outside air if this outside air
is at least 2 degrees colder than the inside air. Ends automatically after 8 hours. Use this
function, for instance, at night to reduce the temperature a few degrees in a warmed-up
room.
Child lock. Locks the control panel. Press the indicated buttons simultaneously for 4
seconds. Ends as soon as you repeat this action.
Child lock. The child lock is activated.
Error. A fault has occurred. Please contact your installer.
Dirty filter. Replace the air filters or contact your installer.
After replacing the filters, press the + and - buttons for 4
seconds.
Basic ventilation. The basic ventilation is activated.
Manual control. Manual control is activated. The ventilation is
not controlled automatically.
Outside temperature higher than within. The ClimaRad will
temporarily not ventilate because the outside temperature is
higher than the inside temperature (warning light flashes).
1u
z
zz
30"
type I type II
The is standard set at 1000 ppm. This means that the ventilation unit starts toair quality
ventilate (air quality indicator light flashes) the moment this limit is exceeded. If you want
to customise the settings you can adjust the air quality with the + and - buttons.
Functions already set up for you
4 sec. 4 sec.
Future comfort today