Closet Maid Indoor Furniture 1775 User manual

1775
1
2
3
12” (30,5 cm)
Shelf & Rod
12” (30,5 cm)
SuperSlide®
16” (40,6 cm)
Shelf & Rod
16” (40,6 cm)
SuperSlide®
with Hang Rod
Push pre-loaded anchor through support
bracket and into drilled hole. Use bottom of
hammer handle to push in pin. For
removal, pry pin out with screwdriver.
Empuje el tarugo precargado por el soporte en
el agujero preforado. Use la parte inferior del
mango del martillo para empujar la clavija
hacia adentro. Para remover, palanquee la
clavija sacándola conun destornillador.
Level shelf. Drill 1/4” hole through wall using
support bracket as guide. DO NOT PUNCH
HOLES.
Nivele la repisa. Perfore un agujero de 6 mm a
través de la pared usando el soporte como
guía. USE TALADRO SOLAMENTE.
Use one support bracket 2-3” from each end of shelf and one every 36” in between. Position support
bracket on shelf as shown. Note proper position for various shelf types.
Coloque un soporte entre 5 cm y 7,6 cm desde cada extremo de la repisa y a cada 91,4 cm entre
medio. Ponga el soporte en la repisa tal como se muestra. Tome nota de la posición correcta para los
diversos tipos de repisas.
75381 0177506
01-84617
If a ClosetMaid® product does not give user complete
satisfaction when installed in
accordance with manufacturer's instructions,
it will be exchanged free of charge. Only the unsatis-
factory part in a multi-piece product
will be exchanged.
Consumer Toll-Free Help Line
1-800-874-0008
(U.S.A and Canada)
Manufacturer reserves the right to
change specifications without notice.
Made in USA
©ClosetMaid Corporation 2005
Ocala, FL 34478-4400