Co-op GOLD Pallisade Hard-Top Gazebo User manual

USE AND CARE GUIDE
Carefully read all instructions and caution warnings before
beginning assembly. Save this Use and Care Guide for
future reference.
Pallisade
Hard-Top Gazebo
10' X 12'

TABLE OF CONTENTS
MATERIAL CONTENTS
ASSEMBLY INSTRUCTIONS
CARE AND MAINTENANCE
SAFETY WARNINGS
WARRANTY
2
4–7
8
8
9
IMPORTANT INSTRUCTIONS
MATERIAL CONTENTS
2
PARTS LIST
1. Read installation and maintenance instructions thoroughly. Be sure to use proper tools, and always
wear personal protection equipment for your safety.
2. Before assembly, inspect the product for damage and ensure all parts are accounted for.
3. Multiple people required for assembly. Do not attempt to assemble alone. Make sure there is
sufficient manpower when assembling or moving the gazebo.
CAUTION: Proper placement of the gazebo
is essential. Do not place the gazebo
underneath electrical lines.
Post 3$ 
Stake slice 3 % 
Long decorative
groove˄left˅3 & 
Long decorative
groove˄right˅3 & 
Short decorative
groove˄left˅
3' 
Short decorative
groove˄right˅3 ' 
Corner Beam 3 ( 
Middle Beam 3) 
Decorative
Groove Connector 3 * 
Left Slot 3+ 
Right Slot 3 + 

3
MATERIAL CONTENTS
PARTS LIST
Middle Slot 3 + 
“F”Baffle 1 3 , 
“F”Baffle 2 3 , 
“F”Baffle 3 3, 
Left Arc
support Bar 3 - 
Right Arc
support Bar 3- 
Corner Support 3 . 
Small Roof
Cover 3 / 
Roof connector 3 0 
Hook 3 1 
Post up
connect piece 3 2 
Corner Cover 3 3 
Middle Cover 3 3 
Upper Closure
plate 3 4 
Middle Closure
plate 3 4 
Left small PC
board 3 5 
Left big PC
board 3 5 
Middle Board 3 5 
Right small PC
board 3 5 
Right big PC
board 3 5 
Netting 3 6 
HARDWARE PACK 1
$$ +Bolt M6X 3&6
%% +Flat Washer M6 3&6
&& +Bolt M6X35 3&6
'' +6FUHZV67[ 3&6
(( +Bolt M6;15 3&6
:: +M6 Wrench 3&6

4
Fig.1: Attach stake slice(B) on post(A) and fix them tightly by bolt(AA) and flat washer(BB)
Fig.2: Attach decorative groove connector(G) to decorative grooves(C1&C2) and fix them tightly by
bolt(AA) and flat washer (BB), same assembly for grooves(D1&D2)
Fig.3: Attach Post(A) to decorative grooves(C1&C2) and fix them tightly by bolt(CC) and flat
washer(BB), same assembly for grooves(D1&D2)
Fig.4: Attach decorative grooves(C1, C2) to post(A)from the outside and fix them tightly by bolt(AA),
same assembly for grooves(D1&D2)
Fig.5: Attach the corner cover(P1) to decorative grooves, and fix tightly by bolt(DD)
Fig.6: Attach the middle cover(P2) to decorative grooves and fix tightly by bolt(DD)
ASSEMBLY INSTRUCTIONS

5
HARDWARE PACK 2
%% M6 Flat :asher 3&6
$$ M6X Bolt 3&6
ASSEMBLY INSTRUCTIONS
Fig.9: Use bolt(AA) and washer(BB)to lock beam(E) to roof connector(M)
Fig.10: Connect piece(O) on the top of post(A),using bolt(AA)and washer(BB) to lock the bottom of
corner beam(E), post(A) and connect piece(O) together.
Fig.11: Use bolt(AA) and flat washer(BB) to lock middle beam(F) to roof connector(M).
Fig.7: Use bolt(AA)and flat washer(BB) to lock corner support(K) to groove(C1, C2, D1, D2)
Fig.8: Use bolt(EE) and washer(BB) to lock support bar (J1, J2) to decorative groove(C1, C2, D1, D2)
and post(A)
+
+

6
HARDWARE PACK 3
ASSEMBLY INSTRUCTIONS
Fig.14: Insert PC board(R3) into the gazebo top, and then insert middle slot(H3) and another PC
board(R3) into the gazebo top (Note: ”on” side is upper side).
Fig.15: Insert PC board(R1) into the gazebo top, and then insert slot(H1) and PC board(R2) into the
gazebo top. Use the same method to install the PC board(R4) and PC board(R5)).
Fig.16: Cover the bottom of PC boards with “F” Baffle(I3). Insert “F” Baffle (I1 and I2) in the same way.
Fig.12: Use bolt(AA) and washer(BB) to lock the bottom of the middle beam(F) to the decorative
groove(C1, C2, D1, D2)
Fig.13: Put small roof cover(L) on roof connector(M) using bolt(AA) and washer(BB); lock tightly.
Assemble hook(N) to the roof connector(M).
%% M6 Flat :asher 3&6
$$ M6X Bolt 3&6
+
+

7
ASSEMBLY INSTRUCTIONS
FF + ĭ*0mm Stake 12 PCS
GGPlastic 5ing 52 PCS
Fig.17: Insert middle plate(Q2) into the
bottom of middle beam(F) by bolt(AA)
and washer(BB).
Fig.18: Insert corner plate(Q1) into the bottom
of corner beam(E) by bolt(AA) and
washer(BB)
Fig.19: Use hook(GG) to attach the netting(S) to the netting tube.
Fig.20: Use the velcro strap to connect netting(S) to the post(A).
Fig.21: Fix the gazebo on the ground using stake(FF).
3

8
CARE AND MAINTENANCE
SAFETY WARNINGS
 To prevent scratching paint, use care when assembling and handling the product. Should any
scratching or damage occur, cover the scratch immediately with rust-inhibiting paint (not
included).
 Any surface rust that may occur if protective coatings are scratched can be removed with a light
application of regular cooking oil.
 Check all screws and nuts periodically for tightness. Tighten them if required.
 Do not use bleach, acid or other abrasive cleaners on the roof panels or frame.
 Remove the QHWWLQJduring bad weather and windy conditions, and store indoors during winter.
Curtains and netting should also be removed and stored indoors.
 The top snow load is 600 lb. During snowy days, remove snow from the top of the gazebo when the
snow is deeper than 10”.
1. Do not climb on top of the gazebo. Falling off can result in serious injury or death.
2. Do not leave the gazebo where a risk of high wind exists, as possible damage could occur to the
structure.
3. Keep all flame and heat sources away from the gazebo fabric. The fabric meets CPAI-84
specifications for flame resistance, but it is not fireproof. The fabric will burn if left in continuous
contact with any flame source. The application of any foreign substance to the gazebo fabric may
render the flame-resistant properties ineffective.

9
WARRANTY
VALID ONLY WITH ORIGINAL PURCHASE RECEIPT.
WARRANTY: Co-op offers to the original purchaser a POF-year limited warrant on the frame of CO-
OP® GOLD Gazebos in the event of any manufacturing defect in material and workmanship during
normal residential use within five years from the date of purchase.
Co-op offers the original purchaser a one-year limited warranty on the finish of CO-OP® GOLD Gazebos
against blistering, peeling or cracking within one year from the date of purchase.
WARRANTY COVERAGE: Co-op will replace at no charge (excluding labour) any CO-OP® GOLD
Gazebo that is proven to be defective under normal use. An equivalent replacement will be issued to
the original owner provided the defective gazebo was used and cleaned as recommended and not
damaged because of abuse, misuse or negligence. Chips, scratches and stains are not deemed to be
manufacturing defects. Please refer to the care and cleaning instructions to maintain your furniture in
its original appearance.
This warranty gives you specific legal rights, and you may also have other rights that may vary from
province to province.
The terms of this warranty are subject to change without notice.
Made in China
Manufactured for and distributed by Federated Co-operatives Limited
CO-OP® design trademark and CO-OP® ®Registered trademarks of Federated Co-operatives Limited, Saskatoon S7K 3M9
11/2019 Federated Co-operatives Limited.