Forever Redwood PARQUET WOODEN SHOWER BENCH User manual

Parquet Wooden Shower Bench www.foreverredwood.com
866.332.2403; Outside the US: 619.600.5630 7am-7pm Pacific Time, Monday-Saturday
Assembly Instructions for:
PARQUET WOODEN SHOWER BENCH

Parquet Wooden Shower Bench www.foreverredwood.com
CONTENT OF BOXES
Quantity
Description
Drawing
1
Seat
2
Legs
2
Diagonal
Supports
8
Bolts 3 ½” x 5/16”, Washers and Nuts
4
Deck Screw (If apply)

Parquet Wooden Shower Bench www.foreverredwood.com
ASSEMBLY INSTRUCTIONS
Thank you for purchasing Forever Redwood patio furniture. Forever Redwood is built by Old-Growth Again
Restoration Forestry (OGA).OGA is dedicated to restoration forestry. Sales of patio furniture finance our
restoration work in California redwood forestlands.
Tools required: ½-inch ratchet, a square head screwdriver and a mallet or small hammer.
Your furniture was fully assembled in the shop prior to being disassembled for shipping. All the parts fit. The parts
that go together have the same numbers written next to the predrilled holes they attach to. Please take the time to
align the parts with the numbers. If you are forcing a bolt in, the part may be turned around or not aligned properly.
Tap the bolt all the way into the wood to set it, then add a washer and lightly tighten. Don’t over tighten or you will
crush the redwood.
Step 1: Attach legs to seat with 2 bolts (3 ½” x 5/16”), washers & nuts per side. Align the predrilled holes,
tap the bolt all the way in to set it into the wood and then add a washer and tighten the nut. Make sure you
are attaching the correct side –if the bolts do not line up, just move the leg over to the other side of the
bench seat. The bolts should tap into their hole. If you are using force, the leg probably belongs on the other
end of the bench seat. Do not over tighten the bolts or you’ll crush through the redwood and weaken the
bench.
Step 2: Attach diagonal supports to legs with bolts (3 ½” x 5/16”), washers & nuts as shown below:

Parquet Wooden Shower Bench www.foreverredwood.com
Case 1: For large benches
Case 2: For small benches
Case 3: For tiny benches
Thank you. If you have any questions, please call or email us.
Larger Benches –2 bolts to attach
each diagonal Support
Tiny Benches –Could be 32” or less. 2 deck screws
to attach each diagonal support to bench top and
one carriage bolt to attach each diagonal support to
each leg
Small Benches –1 bolt to attach
each diagonal support to legs and 1
bolt to attach both diagonal
supports to bench top