Coaster Nightstand 302352 User manual

ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
Fine Furniture for every stage of life
302352
Nightstand
REVISION 0 : 05/16/2019
REVISION 1 : 03/30/2022PAGE 1 OF 4
COASTERFURNITURE.COM

ITEM:302352
ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS:
1. Remove hardware from box and sort b
y
size.
2. Please check to see that all hardware and parts are present prior to start of assembl
y
.
WARNING!
2. This product is for home use onl
y
and not intended for commercial establishments.
ASSEMBLY TIME
A NIGHTSTAND 1PC
B LEG 4PCS
1FLAT HEAD SCREW
(Φ4 X 20mm - RBW) 12PCS
2FLAT WASHER
(Φ7 X 13mm X 2.0 - RBW) 12PCS
NOTE:
Phillips head screw driver is required in the assembly process; however, manufacturer does not provide this item.
COASTERFURNITURE.COM
1. Don’t attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
PARTS IDENTIFICATION
10 MINUTES
PAGE 2 OF 4
3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
HARDWARE IDENTIFICATION

ITEM: 302352
ASSEMBLY INSTRUCTIONS
STEP 1
STEP 2
STEP 3
COMPLETE
COASTERFURNITURE.COM
PAGE 3 OF 4

ANTI-TIPPING INSTALLMENT INSTRUCTIONS
STEP 1
STEP 3
STEP 2
FURNITURE TIPPING RESTRAINT
WARNING
Injury may result from tipping furniture.
This restraint may protect agai nst tipping furniture.
Do not allow children to climb on furniture.
This restraint is not a substitute for proper adult superv ision.
Failure to detach this restraint before moving the furniture may result in injury and damag e.
This tip restraint must be attached to a wall
stud using long screw enclosed.
Attach a bracket securely to the back top rail of
the furniture using short screw provided, through
the smaller hole.
Place the furniture into position so both mounting brack
e ts are vertically in line. Lace the end of the
restraint strap through the larger hole in each mounting bracket. Bring both ends together and slide
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of the furniture. Attach the
wall stud using the long screw provided, through
the smaller hole.
WALL
Confirm that the strap is securely laced and locked.
COASTERFURNITURE.COM
PAGE 4 OF 4
the flast end through the locking end and draw it through until all slack is removed
WALL
ITEM: 302352

COASTERFURNITURE.COM
Note : Dimension tolerance ±5%
ITEM: 302352
INNER SIZE OF DRAWER: 12.87" X 19.45" X 9.33"