COASTLINE HARBOR VIEW CHAIR 301 User manual

Page 1
REV B
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING. Carefully remove contents from
box. Make sure that all parts and hardware are included using the Parts List below.
COASTLINE CASUAL
11 Industrial Drive
Coventry, Rhode Island 02816
ASSEMBLY INSTRUCTIONS
HARBOR VIEW CHAIR
301
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
75mm Connector Bolt (Actual Size)
Part Code: 18/8-1/4-20-75B x 8
60mm Connector Bolt (Actual Size)
Part Code: 18/8-1/4-20-60B x 2
Part Code: 4MMALLEN
4mm Allen Wrench (Actual Size)
x 1
Right & Left Arm Set
x 1
Right & Left Leg Set
x 1
Seat Assembly
x 1
Back Assembly
x 1
1/4 Lock Washer (Actual Size)
Part Code: 18/8-1/4LW x 8
1/4 Flat Washer (Actual Size)
Part Code: 18/8-1/4FW x 10
x 8
1/4 Nut (Actual Size)
Part Code:
18/8-1/4-20N
Part Code: 18/8-8x1-3/4PFDS
1-3/4 Phillips Head Screw (Actual Size)
x 4
x 2
Lock Nut (Actual Size)
Part Code:
18/8-1/4-20LN

Page 2
REV B
Place Back Assembly on top of
mounting surface of Rear Legs (Part of
Seat Assembly). Push Back Assembly
forward until it meets the last Seat Slat
of the Seat Assembly. Hold Back
Assembly in place and install (4) 1-3/4”
Phillips Head Screws into pre-drilled
holes on each side of the Lower Yoke
(No pre-drilled holes on Rear Legs).
Arms should be installed with curve
cutout on the inside of the chair. Place
Arm on top of Front Leg. Align
pre-drilled hole in the Underarm support
with the pre-drilled hole located at the
top of the Front Leg. Install a 75mm
connector bolt, starting from the Front
Leg through the Underarm. Finger tight-
en flat washer, lock washer and nut. Do
not fully tighten at this time. Repeat pro-
cess for opposite Arm.
Place Seat Assembly on it’s side, using
a flat clean surface. Place Leg with
mounted support over seat assembly,
while making sure the mounted support
is facing outward. Insert (3) 75mm
connector bolts through the pre-drilled
holes in the Front Leg and align this
with the pre-drilled holes in the seat
assembly. Finger tighten flat washer,
lock washer, and attach nut on each
bolt. Do not fully tighten at this time. Flip
the assembly over and repeat process
for opposite Leg.
2ATTACH LEGS TO SEAT ASSEMBLY 3ATTACH ARMS TO TOP OF LEGS
4ATTACH ARMS TO BACK ASSEMBLY 5ATTACH BACK ASSEMBLY TO SEAT
ASSEMBLY Phillips Head Screw Driver Required (Not Included)
6TIGHTEN ALL CONNECTIONS AVOIDING OVER TIGHTENING; DOING SO CAN CAUSE DAMAGE TO
THE PRODUCT 7/16 Wrench or Socket Required (Not Included) and 4mm Allen Wrench Required (Included)
Place Upper Yoke of the Back
Assembly underneath arms, aligning pre-
drilled holes. Install (1) 60mm
connector bolt through pre-drilled hole of the
Arm and through Upper Yoke. Finger tighten
flat washer and lock nut (18/8-1/4-20LN). Do
not fully tighten at this time. Repeat process
for opposite Arm.