Colebrook Bosson Saunders WISHBONE User manual

issue No.1
WARNING
MAINTENANCE and INSPECTION
• Do not use this product for any purpose other than that for which it was designed.
• Do not manipulate this product in a rough manner.
• Do not apply more weight than advised.
• Supported weight must not exceed 10kg (22lb).
• Hold the monitor tightly when making adjustments.
• Care should be taken to avoid trapping fingers.
• Do not dismantle or remodel the arms.
• Ensure sockets are tightened equally and the movement joint is securely held in the plastic sockets.
• Do not use if screws are loose.
• Ensure all screws are tightened.
18 Bowden Street Kennington London SE11 4DS
tel: [phone] fax: [phone] e.mail: [email protected]
www.cbs-products.com
WISHBONE INSTRUCTION

30
20
nylon washer
stud
M12 washer
M12 nut
spreader plate (*option)
neoprene pad
grommet
bar
M12 washer
M12 nut
stud
plastic grommet (*option)
Through desk
Grommet
Post
Extension
1-a
1-b
1-c
2-1
2-2
Extension stud
Use the special tool for tightening the Wishbone post.
DO NOT attach the monitor before assembling post.
DO NOT attach the monitor before assembling post.
DO NOT attach the monitor before assembling post.
•Small clamp (WSH/SCLM38, WSH/SCLM63) to only be used with WSH/003
and Tool bar.
Clamp

O-Ring
VESA100mm
VESA75mm
Assembling and Adjusting arms
Attaching arm to post
Attaching VESA plate to monitor
Attaching arm to toolbar
3-1
3-2
4-a
4-b
if necessary, insert the plastic
socket from inside the C-piece.
Screws for screen are NOT provided,
please contact your monitor provider.
Ensure both plastic sockets are
screwed in sufficiently to allow
fixing of the movement joint.
Using a 6 mm allen key, tighten
both plastic sockets equally to
secure the movement joint
centrally within the C-piece. The
joint is secure when it rotates
with a small amount of resistance.
Ensure sockets are equally tightened and the movement joint is
securely held in the plastic sockets.
Non quick release
movement joint
Quick release
movement joint
Position O-ring at desired height. Thread Wishbone over post.
Ensure the screw or pig tail is
tightened sufficiently after fixing or
adjustment.
Remove the monitor from the arm when
fixing or adjusting.

Back to back bracket
Toolbar bracket
Slat wall & wall mounting bracket
Screws for wall mounting are NOT provided.
Ensure the top plate has a pin.
Assembling toolbar bracket and slat wall or wall mounting bracket
Assembling back to back bracket

C post
Forearm post
Forears
Wishbone
Standard arms
Back to back
Back to back
Cap
O-Ring
Extension Post
Post
Nut & Washer
38mm Nylon washer
Extension
Stud (50mm)
Cable
Management
Clip
Stud
(70,80,130mm)
Nut & Washer
Desk-bar
Grommet
Clamp
Stud
(70,80,130mm)
Forearm Toolbar
C-piece extended Toolbar
Toolbar
Forearm
slat wall & wall bracket with post
Wishbone
slat wall & wall bracket with post
Wishbone standard system
Extension slat wall & wall bracket with post
Extension tool bar bracket with post
C-piece Toolbar
C-piece
slat wall & wall bracket with post
C-piece extended
slat wall & wall bracket with post
C arms
Back to back
Wishbone Toolbar