Coleman American Heritage Weathermaster 9232B129 User manual

AMERICAN HERITAGE®
WEATHERMASTER®CABIN 12'X9'
1Layout & Positioning of Tent
– Layout and position tent with door
facing desired direction. (illus. 1)
– Stake down tent, starting with
the corners. Do not stretch
too tight. Angle the stakes
slightly toward the tent.
(illus. 2) Keep the floor taught.
– Unzip the door.
2Assemble & Place Roof Poles
– Assemble all chain shock-corded
roof poles. When assembled will
form a continuous arch with both
ends pointing down. (illus. 3)
– Insert the curved ridge roof poles
through the roof pole sleeves.
(illus. 4)
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear
of rocks, branches and other
hard or sharp objects.
– Do not set up your tent
under trees.
–For best results in windy
conditions, position the end
of tent into the wind.
(3) Curved Ridge Roof Poles
Part No. 9232B401
(4) End Brace Poles
Part No. 9232B110
(2) Center Adjustable- Poles
(Red Sticker) Part No. 9232B109
(2) Center Brace Poles
(Red Sticker) Part No. 9232B410
Rainfly Part No. 9232B400
Instructions apply to Part Number 9232B129
illus. 3 Curved roof pole assembly.
illus. 4 Curved roof pole system shown
inserted through pole sleeves.
illus. 2
Stake loops
properly staked
Front door
Roof sleeve
illus. 1
Pole sleeves
Shock-corded poles
Forms an arch
POLE ASSEMBLY PARTS

Rainfly guylines
End guyline
Rainfly
illus. 9
Tent shown completely set-up.
Note the different angles of the end brace poles.
Brace pole with
hole for rainfly
“S” hooks
illus. 10
Stake out tent with adjustable guylines.
Slide the disc up the rope to tighten guyline.
3Raise Center of Tent
– Assemble center adjustable & brace poles by
inserting the brace pole into the adjustable
center pole. (illus. 7)
– Insert square end of brace poles into
curved roof poles and raise tent upright.
(illus. 5, 6, 7)
– Extend the center brace pole
upward and squeeze down on
the handle to lock brace pole
into place. (illus. 5, 7)
4Raise Sides of Tent
– Assemble shock-corded end brace poles.
– Insert brace poles into end curved roof poles.
MAKE SURE when attaching the brace
poles to the curved poles that the bottom of
the brace pole naturally points down and
toward the center of the tent. (illus. 9)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
– Attach and stake out end guylines.
(illus. 9, 10)
– Drape rainfly over tent and attach “S”
hooks on rainfly into holes in brace
poles. (illus. 9)
– Attach guylines to the ends of the
rainfly, 3 guylines at each end, and
stake out. (illus. 9, 10)
illus. 7
Squeeze to
lock into place
illus. 5
Shown with center brace
poles in position and
curved poles
through pole
sleeves.
Center brace pole
illus. 6 When attaching the
brace poles to the curved
poles make sure that the
brace poles naturally point
straight down.
Brace pole
Curved
poles in
pole sleeve
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN THAILAND
PRINTED IN THAILAND Rev. 7/04
Things You Should Know
•Under certain conditions (cold weather, high humidity, etc.) condensation will form on
the inside surfaces of your tent. Condensation is caused by water vapor from your
breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through
the tent fabric. It can be minimized by removing wet clothing from your tent and by
providing good ventilation through the tent.
•Never store tent, even for a short period of time, without drying it thoroughly and
brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate
storage bag.
•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER
PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
•TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•Seam sealer has not been provided with your tent. For additional protection we
recommend seam sealing your tent prior to camping. Seam sealer may be purchased
through your local retailer or at your local sporting goods store.
•Do not leave your tent set-up for weeks at a time, be aware that exposure to
the ultraviolet rays of the sun can seriously damage material and/or cause it to
become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84.The fabric will burn if left in continuous contact
with any flame source.The application of any foreign substance to the tent
fabric may render the flame-resistant properties ineffective.
illus. 8
Insert squeeze
pin into pole