Coleman 9392-133 User manual

Pole Assembly
–For easier setup, do not extend poles
completely.
–Go to the end of pole with the
spring clip and assemble all but the last
shock corded section.The pole should
curve down plus one section. (illus. 2)
–Insert the end with the spring clip into
one of the hub ports until it clicks into
position. (illus. 1, 2)
–Repeat for each of the four remaining
poles. (illus. 2)
–Assemble and connect one pole at a
time to the hub.
13’x13’ SCREEN HAVEN
1
WhenYou Are Ready To Set Up Your
Shelter
–Select a level area clear of rocks,
branches and other hard or sharp objects.
–Do not set up your shelter under trees.
–For easier set up, two or more people
are recommended.
POLE ASSEMBLY PARTS
Instructions apply to Part Number 9392-133
Poles Part No. 9191-313
Hub Part No. 9191-330
Illus. 2
Partially assembled
frame locked into hub
Illus. 1
Poles inserted
into hub
Hub
Hub
Spring Clip
Pole

illus. 6
Completed shelter with guy
lines staked out
2
PRINTED IN SRI LANKA Rev. 10/03
Things You Should Know
• Never store shelter, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your shelter.Use separate storage bag provided.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
• SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
• Do not leave your shelter set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The fabric will
burn if left in continuous contact with any flame source.The application of
any foreign substance to the tent fabric may render the flame-resistant
properties ineffective.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
Attach Shelter to
Frame
–Drape the canopy over the frame (illus. 3)
–Position each corner over the curved
portion of the pole.
–Fully extend each pole by
completing the interlocking of the
shock corded pole sections.
–Insert the brass hook into the hole
near the base of the pole (illus. 4)
–From the inside of the shelter secure
the pole frame to the shelter with the
hook and loop closures.
–Adjust poles to pull the shelter taut
and stake down through the fabric
loops at the end of each pole (illus. 5)
–Adjust hook straps to increase
tautness (illus. 5)
–Attach guy lines to fabric
guy loops at each corner
and stake out (illus. 6)
illus. 3 Fabric draped over
partially assembled frame
illus. 4
Insert Brass Hook
into hole near the
base of the pole
illus. 5
Stake through
Stake Loop Hook Strap
Use to adjust
or tighten
canopy
Stake Loop Stake