Coleman Screened WeatherMaster 9232A379 User manual

Screened WeatherMaster™17'x9'
1Layout & Positioning of
Tent
–Layout and position tent with screen room
facing desired direction. (illus. 1)
–Stake down tent, starting with
the corners. Do not stretch
too tight. Angle the Stakes
slightly toward the tent.
(illus. 2) Keep the floor taut.
–Stake down the remainder of
the stake loops–Unzip the door
2Assemble & Place Roof
Poles
–Assemble all chain shock-corded
Roof Poles. When assembled will
form a continuous arch with both
ends pointing down. (illus. 3)
–Select Center Roof Pole with
Red stickers, then insert through
the center roof pole sleeve. (illus. 4)
–Select Front Roof Pole, with Red sticker,
then insert through the roof pole
sleeve at Front over Screen Room
(illus. 4)
–Select Rear Roof Pole, with Blue
sticker, then insert through the roof
sleeve at the Rear of tent (illus. 4)
WhenYou Are Ready
To Set UpYourTent
–Select a level campsite
clear of rocks, branches
and other hard or sharp
objects.
–Do not set up your tent
under trees.
–For best results in windy
conditions, position the
end of tent into the wind.
–See owners manual for
more tips.
Center Curved Roof Poles
(Red Sticker) Part No. 9232-372
Rear (Blue Sticker) Part No. 9232-373
Center Upright Poles
(Red Sticker) Part No. 9232A374
Rear Brace Poles
(Blue Sticker) Part No. 9232A375
Rainfly Part No. 9232-371
Instructions apply to Part Number 9232A379
Illus. 3 Curved Roof Pole assembly.
Illus. 4 Curved Roof Pole system shown
inserted through pole sleeve. Red
sticker poles go in center pole sleeve. Red sticker for
front sleeve and Blue sticker in rear pole sleeve.
Illus. 2
Stake loops
properly staked
Front of
Screen
Door
Roof Sleeve
Illus. 1
Roof Pole Sleeve
Chain corded poles
Forms an arch
Chain shock-corded
POLE ASSEMBLY PARTS

3Raise Center of Tent
–Assemble center shock-corded brace poles (red
sticker, longer poles). Pole should be initially
adjusted to the inner most hole “A”. (illus. 7)
–Insert square end of brace poles into
curved roof poles and raise tent upright.
(illus. 5, 6, 7)
–Brace poles should attach to squeeze
pins at bottom of tent. Illus 5
illus. 5
Shown with both
Center Brace Poles in
position and Curved
pole through
center pole
sleeve.
Center Brace Poles
Front Brace Poles
4
illus. 6 When attaching the Brace
poles to the Curved Poles make sure
that the Brace poles naturally point
straight down.
illus. 9 Tent shown completely
set-up. Note the different angles
of the end Brace Poles. Rainfly
over sleeping area.
Raise Ends of Tent
–Assemble front brace shock-corded
Brace Poles (red sticker)
–Insert (red sticker) Brace Poles into end roof
assemblies. MAKE SURE when attaching the
Brace poles to the curved poles the bottom of
the Brace pole naturally points down and
toward the center of the tent. (illus. 9)
–Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
–Assemble end (blue sticker, round ends)
shock-corded Brace Poles
–Insert (blue sticker) Brace Poles into end
roof assemblies. MAKE SURE when
attaching the Brace poles to the curved
poles the bottom of the Brace pole
naturally points down and toward the
center of the tent. (illus. 9)
–Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
–Adjust poles to accomodate terrain
–Drape Rainfly over sleeping area of
tent, covering the center and rear
poles sleeves. Hook the rainfly onto
brace poles.(illus. 9)
Brace Pole
Curved
poles in
pole sleeve
Rainfly hooks to
Brace Poles
Rev. 10/01
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
illus. 7
Poles should be initially
adjusted to the inner
most hole “A”.
illus. 8
Insert Squeeze
Pin into pole
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
• Seam sealer has not been provided with your tent. It is necessary and
we recommend seam sealing your tent prior to camping. Seam sealer may
be purchased through your local retailer or at your local sporting goods store.
• Do not leave your tent set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage nylon material
and/or cause it to become discolored.
• See owners manual for more tips.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84. The fabric may burn if left in continuous contact
with any flame source. The application of any foreign substance to the
tent fabric may render the flame-resistant properties ineffective.