Coltene BioSonic Suvi Premier User manual

OFF
ON
ZERO MAX
Ultrasonic Scaler QuickStart Guide:
1. Press S button to turn ON the Scaler.
2. Tip Working mode:
3. Select scaler function:
4. Water regulation:
5. Foot Pedal Control:
6. Cleaning:
Scaler
Comprehensive cleaning function:
The cleaning function can be started by pressing C. Water
or disinfectant cleans the water line and handpiece. The
cleaning cycle stops automatically after 80 seconds.
With every push of the Sbutton, the function toggles from:
Scaling with water
Dry mode: scaling without water
Irrigation mode: just water, no scaling
The unit is in standby mode when the power cord is
connected and the green LED is illuminated.
or or
100 %
70 %
40 %
Depress the foot control pedal in the leftmost position and
adjust the water flow with the control ring on the scaler
handpiece until the water is dripping.
The scaler is activated when the foot control pedal is
pressed down. The power is regulated from left/ZERO
to right/MAX within the chosen working mode. In ZERO
position there are two functions:
a) irrigation with no scaling power: hold the footpedal
down.
b) diagnostic light: press the footpedal once.
1
1
2
2
3
4
3
4
Choose the correct working mode that is marked on the
base of each tip by pressing the corresponding working
mode button on the keypad:
7. Push the S button for 3 seconds to turn the scaler OFF.

1.
4.
2.
5.
3.
1. Consult a qualified technician to install to water supply if applicable.
2. Connect the foot control pedal cable to the foot control pedal and to the rear of the unit.
3. Connect the power cord to the unit and the AC power outlet.
6. See Section 4 in the
owner’s guide for Operation
Instructions.
4. Fill the medicament bottle with water or medicament solution. Screw the bottle connector cap onto the bottle and push it onto
the connector on the left side of the unit. When removing the bottle, press first the depressurization button beside the connector.
5. Gently slide a handpiece grip onto the scaler handpiece. Place the scaler tip in the torque wrench and use the torque wrench to
screw the scaler tip clockwise onto the scaler handpiece. Tighten until the resistance causes the torque wrench to begin to slip.
NOTE! Before installing and using the device please read the owner’s guide.
6.b.
Installation
P/N 20004499A
coltene.com
Coltène/Whaledent Inc.
235 Ascot Parkway
Cuyahoga Falls, OH 44223 / USA
Tel. USA & Canada + 1 800 221 3046
+ 1 330 916 8800
Fax [phone]
[e-mail]
Coltène/Whaledent AG
Feldwiesenstrasse 20
9450 Altstätten / Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
Coltène/Whaledent GmbH + Co. KG
Raiffeissenstrasse 30
89129 Langenau / Germany
Tel. [phone]
Fax [phone]
[e-mail]