
2
Your Ultima™ Base has been built to the highest standards
of quality to ensure years of superior service. Please take
the time to read this informative instruction guide and pay
particular attention to the safety information provided.
Here are some additional precautions you can take to re-
duce the risk of injury:
1. Read and understand ALL instructions.
2. Determine, with a physician or therapist, the suitability
of this product for the intended user.
3. To reduce the risk of injury or drowning, NEVER leave
the user unsupervised or unattended while in the bath.
4. SAVE THESE INSTRUCTIONS.
If you require additional assistance, please call Columbia
Medical Customer Service at (800) 454-6612, or e-mail
Thank you for choosing Columbia Medical.
ATTENTION
Before You Begin
NEVER position the Ultima legs at a complete vertical
position. This will cause instability and can cause severe
injury.
The Ultima Bath Chair, when used with the 8890 Rolling
Base, IS NOT INTENDED to be used as a wheelchair.
Use EXTREME CARE when positioning a user and while
moving the unit over obstacles on the floor.
The 8880 Extension Base and 8890 Rolling Base are not
for use with chairs other than the Columbia Ultima Bath
Chair.
3
Assembly Instructions
The stainless steel bases are designed to be used with your Columbia
Ultima™ Stainless Steel Bath Chair. Both bases raise the height of your
bath chair. Advantages of a higher bath chair include easier transfers
and a reduced risk of back strain for the care giver. You will need a
hand-held shower hose in your tub for proper bathing.
Step 1:
Remove unit from the box and
place on a flat surface. Loosen the
TWO blue adjustment knobs by
turning them counter-clockwise.
See Fig. 1
If using the 8800 extension base
(without the casters), make sure to
place the base in the tub before
moving on to Step 2.
Step 2:
Adjust the legs on your Ultima bath chair to the desired position. Place
the rear legs onto the rear channel of the 8880/8890 base unit; the
horizontal base of the legs will fit into the support channel. See Fig. 1
Slowly lower the front legs of the
Ultima chair into the second channel.
If needed, adjust the length of the
8880/8890 base to accommodate the
front legs of bath chair. See Fig. 2
Step 3:
Tighten the blue adjustment knobs by turning them clockwise.
Step 4:
Connect the holding straps, pulling tight to make sure the Velcro is
properly engaged.
Blue knob
Blue knob
rear channel
front channel
(Fig. 1) 8880 shown in example above
(Fig. 2) 8880 shown in example above