COMPASS HEALTH B651 User manual

Find the 1 medium sized screw -
WARNING - medium screw MUST be used for the next
step or damage to the seat will occur. Place medium screw with
washer into center hole through both U bars and into the screw
hole in the seat. Contour of washers should match curve of bar.
DO NOT fully tighten yet.
Encuentra el 1 tornillo de tamaño mediano -
ADVERTENCIA - El tornillo de tamaño mediano DEBE ser
utilizado para el siguiente paso; de lo contrario, se producirán
daños o lesiones. Coloque el tornillo mediano con arandela en el
QTKƂEKQEGPVTCNCVTCXÅUFGCODCUDCTTCUGP7[GPGNQTKƂEKQFGN
tornillo en el asiento. El contorno de la arandela debe coincidir
con la curva de la barra. NO apriete por completo.
Made in China
42-B65100_13 ©2018
Manufactured for: Compass Health Brands Corp.
Middleburg Heights, OH 44130
www.compasshealthbrands.com • 800.376.7263
Seat/
Asiento x 1
Backrest/
Respaldo x 1
Parts List/Lista de Partes
Leg Extensions/
Extensiones de Pierna x 4
Washer/Arandelas x 5
L Bars/
Barras L x 2
Medium Screws/
Tornillos Medianos x 1
Long Screws/
Tornillos Largos x 4
U Bars/
Barras U x 2
Labeled “1” and “2”
B651
WARNING: Read all instructions and warnings prior to assembly and use.
ADVERTENCIA: Lea todas las instrucciones y advertencias antes del ensamblaje y uso.
WEIGHT CAPACITY: 350 lbs
CAPACIDAD DE PESO: 350 libras
2
2
1
2
1
Assembly Instructions/
Instrucciones de montaje
Bath and Shower Seat with Back/
Asiento de baño y ducha con respaldo
1
Figure 2.
Proper alignment of U bars
Back
Medium Screw
1
1
1
1
2
2
Back
Figure 1.
Correct placement of U Bars
Figure 3.
Securing U bars to seat
Place seat face-down on a table or counter with the FRONT
edge closest to you (BACK edge has the shower sprayer
notches, FRONT edge does not). Place U bar labeled “1” in the
groove in the seat which extends from BACK LEFT corner of seat to
RIGHT FRONT corner of seat, as shown in Figure 1., above. Place the
U bar labeled “2” in the other groove, on top of U bar “1.”
NOTE: when placed correctly, the 2 U bars will align at the center as
shown in Figure 2., above.
WARNING: Failure to assemble this bath seat correctly can result in
falls/injuries.
Coloque el asiento boca abajo sobre una mesa o mostrador con el
borde del asiento cerca del borde de la mesa. Coloque la barra en
U etiquetada “1” en la ranura del asiento, de modo que el “1” en
NCDCTTCGUVÅCNNCFQFGNpqGPGNCUKGPVQ%QNQSWGNCDCTTCGP7
GVKSWGVCFCpqGPGNCUKGPVQRCTCSWGGNpqGPNCDCTTCGUVÅCNNCFQ
del “2” en el asiento.
1

Assembly Instructions/
Instrucciones de montaje
Bath and Shower Seat with Back/
Asiento de baño y ducha con respaldo
Slip leg extensions on,
push copper pin and
slide on, line up pin and hole so
pin pops through leg extension
hole completely. Repeat for all
4 legs. Adjust height so all legs
are the same height.
Deslice las extensiones de
pierna, empuje el pasador de
cobre y deslícelo, alinee el
RCUCFQT[GNQTKƂEKQRCTCSWG
el pasador salga por completo
FGNQTKƂEKQFGGZVGPUKÏPFGNC
pierna. Repita para las 4 patas.
Ajuste la altura para que todas
las piernas sean iguales.
Check for stability. Assure all
pins are completely through
the holes and legs are all the same
height. Place Bath and Shower
Bench in shower or bath on a level
surface. Periodically check to assure
that all screws remain tight. Place
Bath and Shower Bench in shower
or bath, on a level surface.
8GTKƂECNCGUVCDKNKFCF#UGIÖTGUG
FGSWGVQFQUNQURCUCFQTGUGUVÅP
EQORNGVCOGPVGCVTCXÅUFGNQU
agujeros y que las patas tengan la
misma altura. Coloque el banco
de seguridad para baño y ducha
en la ducha o el baño. Controle
RGTKÏFKECOGPVGRCTCCUGIWTCTUG
FGSWGVQFQUNQUVQTPKNNQUGUVÅP
apretados.
Place L bar over U bar holes so holes line up. Insert
screws and washers on L bar. Do not tighten yet.
Repeat with other L Bar. Fully tighten the 4 long screws.
Tighten the middle medium screw. Periodically check to
assure that all screws remain tight.
Coloque la barra L sobre los agujeros de la barra en
7RCTCSWGNQUQTKƂEKQUGUVÅPCNKPGCFQU#VQTPKNNGEQP
tornillos largos, incluida la arandela. NO apriete. Repita
con otra barra L. Aprieta los 4 tornillos largos. Apretar
GNVQTPKNNQOGFKCPQ%QPVTQNGRGTKÏFKECOGPVGRCTC
CUGIWTCTUGFGSWGVQFQUNQUVQTPKNNQUGUVÅPCRTGVCFQU
4
Attach backrest to both L bars. Press in the
pop pins and line up with backrest holes.
Assure pins are completely through the holes.
Fije el respaldo a ambas barras en L. Presione
los pernos y alinee con los agujeros en el
TGURCNFQ#UGIÖTGUGFGSWGNQURCUCFQTGUGUVÅP
EQORNGVCOGPVGCVTCXÅUFGNQUCIWLGTQU
3
Long Screws
1
1
2
2
See additional warnings on enclosed warnings guide.
2
6
5
Made in China
42-B65100_13 ©2018
Manufactured for: Compass Health Brands Corp.
Middleburg Heights, OH 44130
www.compasshealthbrands.com • 800.376.7263