CompuLab FIT-PC4 Use and care manual

Hayetsira St. 17, Yokneam, Israel
Tel:
[phone]
Fax:
[phone]
www.compulab.co.il
21-Nov-18
Fit-pc4 battery replacement guide
This document instructs to replace an RTC backup battery on the fit-pc4 model
This document is derived from the Errata note - http://fit-pc.com/wiki/index.php/Fit-PC4_RTC_Battery_Erratum
It applies to models that has detachable non-rechargeable battery board design.
oTo determine, please check that D15 and R59 parts, below the RAM socket, were removed, see illustration below :
Instructions
Place your FIT-PC4 upside down, so you can
easily access service door

Hayetsira St. 17, Yokneam, Israel
Tel:
[phone]
Fax:
[phone]
www.compulab.co.il
Remove the service door from FIT-PC4.
Remove four Philips screws at the FIT-PC4
corners and carefully detach the back panel.
Remove the face module’s Philips screw,
and detach the face module by lifting it up

Hayetsira St. 17, Yokneam, Israel
Tel:
[phone]
Fax:
[phone]
www.compulab.co.il
Now you have easy access to the RTC backup
battery, attached to the P32 connector.
To remove the battery, you need slightly to
lift up the battery plug attached to the P32
connector and pull away the plug from the
P32 connector.
Please use extra care, not to damage U19 IC
located between P32 and battery
connector.
Insert the replacement battery into P32
connector
Assemble back the face module, the back
panel and the service door, performing in
the reverse order steps 1 to 4.