IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety pre-
cautions should always be taken, including
the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER – As with most electrical
appliances, electrical parts are electrically
live even when the switch is off. To reduce
the risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in or drop into water or
other liquids.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING – To reduce the risk
of burns, electric shock, fire, or injury to
persons:
1. An appliance should never be left
unattended when plugged in.
2. Do not pull, twist or wrap line cord
around appliance.
3. Close supervision is necessary when this
appliance is used by, on, or near children
or individuals with certain disabilities.
4. Use this appliance only for its intended
use as described in the manual. Do not
use attachments not recommended
by Conair.
5. Never operate this appliance if it
has a damaged cord or plug, if it is
not working properly, if it has been
dropped or damaged, or if it has been
dropped into water. Return the appli-
ance to an authorized service center
for examination and repair.
6. Keep the cord away from heated surfaces.
7. Never block the air openings of the appli-
ance or place it on a soft surface, such
as a bed or couch, where the air open-
ings may be blocked. Keep the air open-
ings free of lint, hair, and the like.
8. Never use while sleeping.
9. Never drop or insert any object into any
opening or hose.
10. Do not use outdoors or operate where
aerosol (spray) products are being used
or where oxygen is being administered.
11. Do not use an extension cord with this
appliance.
12. Do not touch hot surfaces of the
appliance. Use the handles or knobs.
13. Do not touch metal “radiator” strips that
hold rollers, as they will be hot.
14. This is not a toy. Keep away from children.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
How to operate your hairsetter with
heated clips:
1. Place hairsetter on a firm, flat surface. With
the lid closed, plug cord into outlet. This
appliance has a polarized plug (one blade is
wider than the other). As a safety feature,
this plug will fit into a polarized outlet only
one way. If the plug does not fit fully into
the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
2. Once plugged in, the red light will go on
and the rollers will heat up quickly. Rollers
are ready to use when the ready dot on
one of the rollers turns transparent/white.
3. Be sure rollers and clips heat with lid
closed, as this will provide the fastest,
most efficient heat up.
4. Hair should be clean and dry or slightly
damp — never wet — when setting.
5. To avoid contact with heat, we suggest
using the clips from the top row first,
followed by the clips on the bottom row.
6. Never leave your hairsetter on and
unattended. Always unplug the hairsetter
when not in use. Allow the hairsetter to
cool down after use and store it in a safe
place.
Please refer to HOW TO CURL YOUR HAIR
for further instructions.
HOW TO CURL YOUR HAIR
1. Position ends of hair on
roller and wind toward
scalp. Roll hair up firmly.
Remove clip from heated
rail and secure over roller.
Rail will heat up 12 clips
at once. If more clips are
needed, add them to
heated rail as you use the initial 12.
2. The firmness of the curl is determined by the
diameter of the roller and the length of time
the roller is left in your hair.
3. For tight, firm curls, use smaller rollers and
leave in the hair for at least 10 minutes
before removing. For soft, wavy curls, use
larger rollers and remove rollers after a
shorter period of time.
4. Removing rollers: Hold roller in one hand
while removing heated clip with the other.
Gently release roller (DO NOT PULL) and
let curl bounce back after roller has been
completely removed. Repeat with other roll-
ers. Let hair cool for one minute for firmly
set curls. Then style your hair into a look that
lasts for hours..
WAVES & VOLUME SETTER
Features
• 20 multi-size flocked hot rollers: 8 extra-large
rollers (1¼ inch), 6 large rollers (1 inch), and
6 medium rollers (¾ inch)
• 20 heated clips
• Cover that keeps heat at the optimal
temperature
Replacement rollers can be ordered online
at www.conair.com by using the QR Code
below or by calling customer service at
1-800-3-CONAIR.
Clips
Extra-Large Rollers Large Rollers
Medium Rollers
To use all roller sizes for full and bouncy curls
Place extra-large rollers at the crown for lift.
Place large rollers on the sides and back and
place medium rollers at the nape of the neck.
Or, randomly space large and medium rollers
around the sides, back and nape for varying
curl sizes.*
*The size of the curl will depend on the length of your
hair, the size of the hair section, and the size of the roller.
The smaller the section and roller, the tighter the curl, the
bigger the section and roller, the looser the curl.
IMPORTANT: After using the hairsetter several
times, you will find the best roller and best tim-
ing for the texture of your hair and the result
you desire.
Aluminum
heating core
Soft
flocking
layer
Ceramic
thermal
layer
Both the clip and
the roller emit heat
for extra hold.
IMPORTANT: After using the hairsetter several
times, you will find the best roller and best tim-
ing for the texture of your hair and the result
you desire.
MEDIDAS DE
SEGURIDAD
IMPORTANTES
Al usar aparatos eléctricos, especialmente en
presencia de niños, siempre se deben tomar
precauciones básicas de seguridad, entre
ellas las siguientes:
LEA TODAS LAS
INSTRUCCIONES ANTES
DEL USO
MANTÉNGALO ALEJADO
DEL AGUA
PELIGRO – Como es el caso de
la mayoría de los aparatos eléctricos, los
componentes eléctricos de este aparato
permanecen en tensión cuando esté enchufado,
incluso si está apagado. Para reducir el riesgo de
electrocución:
1. Siempre desenchufe el aparato
inmediatamente después del uso.
2. No lo use en el baño o la ducha.
3. No coloque ni guarde el aparato donde pueda
caerse o ser empujado a una bañera o un lavabo.
4. No coloque el aparato ni lo deje caer al agua u
otros líquidos.
5. Si el aparato se cae al agua, desenchúfelo
inmediatamente; no intente alcanzarlo en el
agua.
ADVERTENCIA – Para reducir
el riesgo de quemaduras, descarga eléctrica,
incendio o lesiones personales:
1. Nunca descuide/deje el aparato sin
vigilancia mientras esté enchufado.
2. No jale, retuerza ni enrolle el cable
alrededor del aparato.
3. Supervise el uso de este aparato con cuidado
cuando sea usado por, en o cerca de niños o
personas con ciertas discapacidades.
4. Use este producto solo para el uso previsto y
como se describe en este manual. Solo use
accesorios recomendados por el fabricante.
5. No use este aparato si el cable o
enchufe están dañados, si no funciona
correctamente, si está dañado, o después
de una caída/caída en agua; devuélvalo a
un centro de servicio autorizado para su
revisión y reparación.
6. Mantenga el cable lejos de las superficies
calientes.
7. Nunca obstruya los orificios de ventilación,
ni coloque el aparato sobre una superficie
blanda, tal como una cama o un sofá, donde
se puedan obstruir. Mantenga los orificios
de ventilación libres de pelusas, cabellos y
elementos similares.
8. Nunca lo use mientras duerme.
9. Nunca deje caer ni inserte ningún objeto en
ninguna de las aberturas.
10. No use el aparato en exteriores, ni lo
haga funcionar donde se estén usando
productos en aerosol (spray) o donde se esté
administrando oxígeno.
11. No use un cable alargador/de extensión con
este aparato.
12. No toque las superficies calientes; use los
mangos/asas/agarraderas o los botones/
perillas/diales.
13. No toque las tiras de metal que sostienen los
rulos; se ponen muy calientes.
14. Este producto no es un juguete; manténgalo
fuera del alcance de los niños.
GUARDE ESTAS
INSTRUCCIONES
INSTRUCCIONES
DE USO
Cómo usar su set de rulos calientes con clips
calientes:
1. Coloque el aparato sobre una superficie plana
y estable. Cierre la tapa y enchufe el cable
en una toma de corriente. El cable de este
aparato cuenta con un enchufe polarizado
(una pata es más ancha que la otra). Como
medida de seguridad, aquel enchufe se podrá
enchufar de una sola manera en las tomas de
corriente polarizadas. Si el enchufe no entra
en la toma de corriente, inviértalo. Si aun así
no entra completamente, comuníquese con un
electricista. No intente modificar esta función de
seguridad.
2. Después de enchufar el aparato, el indicador
luminoso rojo se encenderá y los rulos se
calentarán rápidamente. Una vez listos, el
indicador térmico se pondrá blanco/translúcido.
3. Deje que los rulos se calienten, manteniendo
la tapa cerrada; esto proporcionará un
calentamiento más rápido y efectivo.
4. El cabello debe estar limpio y seco, o
ligeramente húmedo; nunca use los rulos en
cabello mojado.
5. Para evitar quemarse, se recomienda usar los
clips del nivel superior primero, y luego los del
nivel inferior.
6. Nunca descuide/deje el aparato sin vigilancia
después de encenderlo. Siempre desenchufe el
aparato después del uso. Después del uso deje
que el aparato se enfríe, luego guárdelo en un
lugar seguro.
véase la sección “CÓMO MARCAR EL CABELLO”
para más información.
CÓMO MARCAR EL CABELLO
1. Separe una sección de
cabello, coloque las puntas
en el centro del rulo y enrolle
este hacia el cuero cabelludo.
Enrolle firmemente el cabello.
Retire el clip caliente de la
barra calentadora y sujete el
rulo. El soporte calentará 12
clips al mismo tiempo. Si necesita más clips,
coloque los nuevos clips en el soporte para que
se calienten antes de usarlos.
2. La textura de los rizos dependerá del diámetro
de los rulos y del tiempo que permanezcan en
el cabello.
3. Para conseguir rizos apretados y firmes, use
rulos más pequeños y déjelos en el cabello por
un mínimo de 10 minutos antes de retirarlos.
Para conseguir rizos sueltos y ondas suaves,
use rulos más grandes y déjelos en el cabello
por menos tiempo.
4. Para quitar los rulos: Sostenga el rulo con
una mano y retire el clip con la otra. Deslice
suavemente el rulo (NO LO JALE), dejando que
el cabello rebote libremente. Repita con los
rulos restantes. Deje que el cabello se enfríe
por un minuto antes de peinarlo para fijar
los rizos. Luego, péinese para conseguir un
peinado que durará horas.
SET DE RULOS CALIENTES
PARA ONDAS Y VOLUMEN
Características
• 20 rulos aterciopelados de varios
tamaños: 8 rulos extragrandes de 1¼ in
(32 mm), 6 rulos grande de 1 in (25 mm) y
6 rulos medianos de ¾ in (19 mm)
• 20 clips calientes
• Tapa que mantiene el calor a la
temperatura óptima
Puede pedir rulos de repuesto en www.
conair.com usando el código QR a
continuación o llamando a nuestro servicio
de atención al cliente al 1-800-3-CONAIR.
Clips
Rulos extragrandes Rulos grandes
Rulos medianos
Cómo usar rulos de varios tamaños para
conseguir rizos elásticos con cuerpo
Coloque rulos extragrandes en la coronilla
para levantar la raíz. Coloque rulos grandes
en los costados y en la parte trasera de la
cabeza. Coloque rulos pequeños en la nuca. O
bien, coloque aleatoriamente rulos grandes y
medianos en los costados, la parte trasera y la
nuca para variar el tamaño de los rizos.*
*El tamaño de los rizos dependerá de la longitud del
cabello, del tamaño de la sección de cabello y del
tamaño del rulo. Cuanto más pequeños sean la sección
de cabello y el rulo, más apretados serán los rizos.
Cuanto más grandes sean la sección de cabello y el rulo,
más suaves serán los rizos.
IMPORTANTE: La experiencia le ayudará a
determinar cuánto tiempo dejar los rulos en
el cabello, dependiendo de su textura, para
conseguir los resultados deseados.
Núcleo
térmico de
aluminio
Revestimiento
aterciopelado
suave
Capa
térmica
de
cerámica
Tanto los clips
como los rulos
emiten calor, para
resultados más
duraderos.