Conde Connect User manual

Screen Mounting Instructions
Condeco Group Ltd
2 Harbour Exchange Square London E14 9GE
www.condecosoftware.com

2
Contents
Introduction ........................................................................................................................................................................... 3
Cable routing.......................................................................................................................................................................... 4
Recommended screen height ............................................................................................................................................ 4
Wall mount ............................................................................................................................................................................. 5
Glass mount ........................................................................................................................................................................... 6
Cabling .................................................................................................................................................................................... 7
Contact.................................................................................................................................................................................... 9

3
Introduction
Congratulations to your purchase of you Condeco Connect meeting room screens. This document contains
mounting instructions for your screens.
The screens can be mounted to solid or partition walls using the mounting plate supplied in the box and
suitable fixings.
247mm
183mm
36mm
Mounting plate
120mm x 214mm

4
Cable routing
When deciding where to mount the Condeco room screen please consider the locations of the cable entry
points on the back plate on the top left and right, and the bottom center, highlighted below. Typically, the
power or network cable is running aside, or inside the doorframe, entering the mounting plate from the side.
It’s best practice if possible to fit the device on the side of the door where the handle is.
Cable entry points
Recommended screen height
The final screen height should be determined by local disability access requirements. The ADA (Americans
with Disabilities Act) Guidelines requires that the highest point of interaction is not greater than 48 inches or
1220mm. We find 1150mm – 1170mm from the bottom of the device typically a suitable height.
1150mm-1170mm / 45 inches

5
Wall mount
Once desired screen height is finalised, the back needs to be fixed to the wall using screws to secure the back
plate in position.
Fixing Point
Fixing Point

6
Glass mount
The following illustration shows a screen mounted to Glass.
To fix the screen to a glass wall, attach the double-sided sticky pad* to the back plate, and then firmly press
the back plate against the glass.
If you mount on glass, you may decide that you want to fit a manifestation behind the device to hide cabling
and fixings. We can supply these as an extra on request. If applying these yourself, we recommend
manifestations for wet application.
*Supplied with retail boxed product only.
Screen
Back Plate
Double-
sided
sticky pad

7
Cabling
Once the back plate has been fixed to the wall connect the LAN cable or the power cable to the rear of the
Condeco screen.
Feed the LAN cable through the appropriate cable input hole in the back plate.
Cable Input
(Both Sides)
Cable Input
Network
Port
Network
Cable
Input
Power
Çable

8
Clip the screen on to the back plate and screw the unit in place using the screws provided so it can’t be
removed.
Fixing screws to fix the
unit to the back plate.

9
Contact
Condeco Group
8th Floor Exchange Tower
2 Harbour Exchange Square
London E14 9GE
United Kingdom