Connectland Front panel I/O Box User manual

User’s Manual
GENERAL SPECIFICATION
Front panel I/O BOX with its connected cables
INSTALLATION:
A. Make sure the computer Power is off after shut down the computer and open the
cover of the computer;
B. Remove the 5.25"plastic cover from the computer where is the free bay you want
to install;
C. Install the transfer board to the empty bay,fix it by screws.
D. Connect the cables attached to the BOX to the correct pins where on the Mother
board when the BOX is installed:
1. USB Port
Take the USB module cable to the USB 2.0 connectors which on the Monther board

2.Audio Port
Take Audio module cable to the legacy AC'97 Audio pinheader where on the Monther
board;
3.1394 Port
Take the 1394 cable to the 1394 Port where on the Monther board and Make sure the
housing which connect to the 1394 Pins define is correct;
4.SPDIF_OUT
Connect the S/PDIF module cable to the S/PDIF connector which on the Monther
board

5.Serial ATA Port
First Make sure the 4-pin power cable that from Power supply is connector to the
correct location of the I/O board.And then take the Serial ATA signal cable connect to
the Serial ATA port on the Monther board.
6.Card Reader
Take the 5-pin USB signal cable connect from CN1 location of the Card reader PCB
to the another USB port where on the Monther board.

Front panel I/O Box Connectors
1.USB 2.0 PortThese two 4-pin Universal Serial Bus ports are available for
connecting USB2.0 devices.
2.IEEE 1394 This 6-pin fire wire are connecting IEEE1394 device.
3.SM Connector This port is use for connecting memory SM card
4.CF/MD Connector This port is use for connecting memory CF or MD
card
5.SD/MMC Connector This port is use for connecting memory SD or
MMC card

6.MS Connector This port is use for connecting memory MS card
7.8.S/PDIF digital sound Connector The technology turns your
computer into a heigh-end entertainment system with digital connectivity to
powerful audio and speaker systems.
9.Microphone Connector This port connects a microphone
10.LINE-OUT Connector This port connects a headphone or a speaker
11.DC Power Connector This 4-pin Wafer is use for supply SATA Power
+12V or +5V
12.SATA Connector This port use for connect Serial ATA Equipment
The cables chooseHere you can choose the kinds cables that attached
to I/O BOX
1.

2.

BIOS setup program