Connects2 Vision CAM-25 User manual

- Operating Voltage: 12V DC (Negative Ground)
- Current Consumption: 150mA @ 13.8V
- Effective Pixels: 600
- Viewing Angle: 180 Degrees
- Resolution: 976 x 496
- Minimum Illumination: 0.1 Lux
- Parking Lines: Yes
- Waterproof Rating: IP68
- Operating Temp: -20 to +60 Degrees C
- Night Vision Distance: 4-8m
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any tech-
nical issues. With this in mind, when contacting Connects2, try to provide as much Infor-
mation as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Universal Camera
180° Wide Angle Camera
PRODUCT FEATURES:
DISCLAIMER:
CAM-25

www.connects2.com
2
Connects2Vision
CONTENTS
- Camera with adjustable mounting bracket and 1m cable to mini 6 pin Male
connector
- Camera connection cable 1 with 45cm cable to mini 6 pin Female connector and
1m DC power cable
- Camera connection cable 2 with 6m cable to mini 4 pin Female connector, RCA
Male connector and supply line
- Camera switch cable with 1.6m cable to mini 4 pin Male connector
- Instructions
INSTALLATION
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply. If the camera is to be used in the rear of the vehicle, the Red wire
should be connected to the reversing light circuit or an interface which provides a
reverse signal.
2. Select a suitable location for the camera and ensure that the area is free from all
cables, fuel & oil. Whenever possible, avoid locations that are subject to road dirt &
water spray.
3. Using the supplied mounting bracket, mount the camera in the required position
on the vehicle
4. Connect the camera into connector A on camera connection cable 1 making
sure that the small arrow marks on the Male and Female connectors line up
5. Connect camera connection cable 1 to camera connection cable 2 using the
Male & Female connectors labelled B
6. Connect the RCA Male connector to the display screen and connect the
camera switch cable to camera connection cable 2. Test the camera switch to
ensure correct operation and that the image is displayed correctly on the display
screen. Adjustment of the camera may be required to ensure that the correct
angle of the image is achieved.
7. To swap the image from mirror to normal view, cut the small White looped wire
located on camera connection cable 1.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2