Connects2 Vision CAM-JP1 User manual

www.c2vision-eu.com
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation. Please
ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any technical
issues. With this in mind, when contacting Connects2, try to provide as much Information as
possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Reverse Camera for Jeep Wranglers (JK)
with spare wheel mounting bracket
PRODUCT FEATURES:
CAM-JP1
Image Sensor: 1/3”
TV Lines: 480
Resolution: 720 x 480
Minimum Illumination: 0.1 Lux
TV System: NTSC
Waterproof Rating: IP67
Viewing Angle: 170 Degrees
Parking Lines: Yes (Removable)
Enhanced Performance In Low Light: Yes
Video Output: 1.0V p-p 75ohm
Operating Voltage: 12-24V DC (Negative Ground)
Operating Temperature: -20 Degrees C to +75 Degrees C
DISCLAIMER:
PRODUCT INFORMATION:
The CAM-JP1 is a bracket mounted reversing camera, where the mounting
bracket afxes behind the Jeep Wranglers spare wheel, allowing for ease of
tment.
Vehicle compatibility:
Jeep Wrangler (JK) 2007 - 2018

2
Connects2Vision
www.c2vision-eu.com
INSTALLATION
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2
Cut loop to disable parking
guidelines
CAM-JP1
ACC 12V
Ground
Extension Cable
Power Adapter
Cable
Video RCA
Make Connections to Vehicle/Unit
1. Attach the 6-pin connector from the camera to the coloured connector
from the ‘power adapter cable’.
Note: to remove the parking line feature, cut the small looped wire which is
located on the camera connection cable.
2. Attach the black connector from the ‘power adapter cable’ to either side of
the ‘6m extension cable’.
3. Route the extension cable through the vehicle and attach both green ying
wires to sources of a 12V reverse signal/trigger (e.g. brake light).
4. With the extension routed, connect the remaining 4-pin connector to the
‘video output cable’.
5. Connect the black wire to a suitable source of ground and the red wire to a
switched 12V supply. Lastly plug the yellow RCA into the back of the stereo.
CONTENTS
• Camera with cable to mini Male 6-pin connector
• Power adapter with colour coded Female 6-pin to Female 4-pin connectors
• 6m Male to Male 4-pin extension cable with green ying wires
• Video output cable with red & black wires and yellow RCA connector
• Installation accessories including washers and wire tubing