Connects2 Vision CAM-VW11 User manual

Connects2Vision
User Manual
Brake Light Reverse Camera
for select Volkswagen Vehicles
CAM-VW11
V1.11-20
The information provided in this document is subject to change without notice due to manufacturer
changes and/or improvements to the product/s. This instruction manual is based on documented data
and research. The manufacturer of this product cannot be held responsible for any changes made to
the vehicle by the manufacturer or damages that may occur through the installation of this product in
accordance with the steps outlined herein.
DISCLAIMER
Volkswagen Transformer (T5) 2003 - 2015
Note: this product is for vehicles with a single rear door only.
APPLICATION

www.connects2.com
2
Connects2Vision
Read the manual prior to installation. Technical knowledge is necessary for
installation. Please ensure you use the correct tools to avoid damage to the
vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as
much information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre:
support.connects2.com/tickets/technical/
PRODUCT INFORMATION
CAM-VW11
The CAM-VW11 is a reverse camera solution for Volkswagen vehicles. This ush
mount solution replaces the original brake light casing whilst adding the benet
of a reverse camera feed. With its HD clarity and night vision lighting, you can
reverse with precision. The AV input is perfect for a seamless connection to any
monitor. The CAM-VW11 features automatic switching to the camera feed
upon activation of reverse gear and also boasts removable parking guidelines.
This product is a perfect safety solution for the following vehicles:
TECHNICAL SUPPORT
PRIOR TO INSTALLATION
• 1/3” CMOS sensor
• 720 x 480 resolution
• 1.9mm Lens
• 12V DC operating voltage
• IP68 rated waterproof
• Viewing angle: 90 ° vertical / 170 ° horizontal
• Parking Guidelines (removable)
SPECIFICATIONS
Volkswagen Transporter (T5) 2003 - 2015
Note: this product is for vehicles with a single rear door only.

www.connects2.com 3
Connects2VisionINSTALLATION
2. Begin to remove the pre-existing rear brake light. Once removed, disconnect
all the wiring/light elements from the plastic housing.
4. With the appropriate monitor and placing in mind, begin to thread the
10-metre Extension Cable from the opening of the brake light, through the
vehicle, all the way to the dashboard.
3. Connect the 7-pin connector to the corresponding 7-pin connector on the
Extension Cable. Connect the Black (Ground) & Red (Switched +12V) ying
wires to their relevant source.
5. Attach the 4-pin connector to the Reverse Camera Input source on the
monitor.
6. To test the camera connection, turn on the ignition and put the vehicle into
reverse. The camera feed will populate on screen with parking guidelines (if
loop has been cut).
If camera feed is unresponsive, please uninstall the wiring and reinstall carefully
in accordance with the above steps.
For further help and support, please contact us directly at
support.connects2.com/tickets/technical
and ll out a support ticket with the full details of your issue.
1. Before installation, cut the loop on the camera to enable/disable camera
features.
Loop Cut - Lines On
Loop Uncut - Lines Off

www.connects2.com
4
Connects2Vision
NOTES
MONITOR
(Not Included
with Kit)
REVERSE CAMERA
(Note: image is not a true
representation of actual camera
contained within kit)
10m Extension Cable
Black to GND
Red to +12V
WIRING DIAGRAM