Connoisseurs Sonic Dazzle Stik User manual

Lift outer cover to remove.
3.
Gently rinse the brush head in cool water.
Take care to avoid getting the handle wet.
Allow the bristle to dry.
Replace the cover and store the Dazzle Stik
in a clean dry spot.
5.
Gently rinse the brush head in cool water.
Take care to avoid getting the handle wet.
Allow the bristle to dry.
Replace the cover and store the Dazzle Stik
in a clean dry spot.
5.
1
1
2
3
4
5
3
5
2
Apply a small dab of Dazzle
Drops cleaner to brush tip.
Power switch
on/o
Place brush tip on jewelry, prior to turning the unit ON.
Press the ON/OFF button to activate the motor and start
cleaning.
There is no need to press down hard, allow the bristles to
rotate freely to clean the jewelry.
For best results, rotate the Dazzle Stik around the jewelry to
get into all the crevices.
When cleaning is complete, press the ON/OFF button again to
turn o the motor.
Gently rinse the jewelry in cool water.
4.
4

Remove battery door:
Place ngers on at surfaces in housing.
Gently push down on battery door to remove.
1.
To replace the bristle head:
Align the angled surfaces on the back side of the bristle
head to the angled surfaces on the center pin of the
housing.
Use the alignment indicator as a guide.
Gently push the bristle head onto the center pin until it
locks in place.
6.
To Remove the Bristle head:
Insert a small tool into the slot on the top
of the bristle head. Gently rotate the tool
to pop the bristle head o the housing.
To replace the bristle head:
Align the angled surfaces on the back side of the bristle
head to the angled surfaces on the center pin of the
housing.
Use the alignment indicator as a guide.
Gently push the bristle head onto the center pin until it
locks in place.
6.
To Remove the Bristle head:
Insert a small tool into the slot on the top
of the bristle head. Gently rotate the tool
to pop the bristle head o the housing.