BEFORE OPERATING MACHINE, READ THIS PAGE CAREFULLY.
Before operating the motor, be sure that electric supply voltage and current
are the same as stamped on the nameplate. Fill oil cup. Push in turning knob
and turn the machine over a few revolutions by hand to see if the knife
moves easily.
(1) Use air hose or bellows with proper eye shields and blow lint out of
motor and sharpener twice a week.
(2) Remove cover over cam and clean out lint around screw mechanism in
sharpener once a week.
(3) Remove knife and clean slides with slot cleaner at least once a day
(4) To prevent undue accumulation of lint, do not oil plate rollers.
(5) If rollers stick, remove from plate and wash in cleaning solvent.
This machine is equipped with a
sharp knife. Keep hands away from
the knife area at all times. Use
control levers and handles only when
operating or handling machine
Do not operate sharpener without
knife in machine or the sharpener
will be damaged.
Take the machine out of the lay. Drop
pressure foot by means of pressure
foot lever located next to machine
operating handle. Press release lever
downward with a slow, firm pressure
to engage sharpening mechanism. Too fast
lever action may cause lever to lock. lf
this occurs, lift latch lever and start
Lever. After a few tries you will feel
correct operating pressure.
knife,
shall turn "C" to
bottom, and make knife
shark lowest point "A" to
below 2-
.B"
From the library of: Superior Sewing Machine & Supply LLC
