Coonara 8000 Series User manual

8000 Series Thermostat Remote Control
QUICK START
PAIRING YOUR REMOTE TO YOUR HEATER
•TURN OFF THE HEATER AT THE POWER POINT
•REMOVE THE BATTERIES FROM THE REMOTE
NOTE: IF YOU ARE REPLACING AN EXISTING REMOTE ENSURE OLD REMOTES
BATTERIES ARE ALSO REMOVED.
•AFTER ONE MINUTE TURN THE POWER BACK ON TO THE HEATER AND
PUT THE BATTERIES IN YOUR REMOTE
•WITHIN 30 SECONDS OF PUTTING THE BATTERIES IN AND BEFORE
PRESSING ANY OTHER BUTTONS. YOU MUST PRESS THE FOLLOWING
BUTTONS ON THE REMOTEE P T T
NOTE: THE 4 BUTTON PRESSES NEED TO BE PRESSED FAIRLY QUICKLY IN SEQUENCE
•IF YOU HAVE ENTERED THE SEQUENCE CORRECTLY THE LETTERS LC
WILL APPEAR ON THE SCREEN. AS SOON AS YOU SEE LC DISPLAYED
PRESS THE POWER BUTTON AND THE HEATER WILL START
•IF YOU DO NOT SEE LC APPEAR ON THE SCREEN KEEP TRYING THE 4
BUTTON SEQUENCE UNTIL YOU SEE LC , THEN HIT THE POWER BUTTON
NOTE: YOU ONLY HAVE 30 SECONDS FROM TURNING YOUR POWER ON
TO THE HEATER TO PAIR YOUR REMOTE, IF IT IS NOT DONE WITHIN THIS
TIME THE HEATER WILL LOCK OUT AND YOU WILL HAVE TO START OVER.
OK BUTTON
THE OK BUTTON SHOULD ONLY BE PRESSED WHEN ENTERING VALUES IN THE
TIME/DATE AND SCHEDULE PROGRAMMING MODE. DO NOT USE THE OK
BUTTON WHEN ADJUSTING TEMPERATURES IN MANUAL OR AUTO MODE.
SET TIME & DATE
•WITH THE REMOTE IN THE OFF POSITION HOLD THE T BUTTON, YOU
WILL SEE THE HOUR START TO FLASH, RELEASE THE T BUTTON AND USE
THE UP AND DOWN ARROWS TO SET THE HOUR, MINUTES AND DAY.
ONCE YOU HAVE CHOSEN WHAT YOU WANT PRESS OK.

MANUAL MODE
•PRESS THE ‘MODE’ BUTTON UNTIL ‘MANUAL’ IS DISPLAYED ON THE
REMOTE
•YOU CAN THEN PRESS THE UP AND DOWN ARROWS TO SELECT THE
FOLLOWING SETTINGS;
1 = LOW
2 = MEDIUM
3 = HIGH
AUTO MODE
•PRESS THE ‘MODE’ BUTTON UNTIL ‘AUTO’ IS DISPLAYED ON THE
REMOTE
•YOU CAN THEN PRESS THE UP AND DOWN ARROWS TO SELECT THE
DESIRED TEMPERATURE
•AS THE ROOM HEATS UP THE THERMOSTAT WILL RISE 1 DEGREE
ABOVE SET TEMPERATURE AND WILL THEN TURN THE FLAME OFF AND
COME BACK ON WHEN TEMPERATURE DROPS 1 DEGREE BELOW THE
SET TEMPERATURE
EG: IF YOU SET YOUR REMOTE TO 20 DEGRESS, THE TEMPERATURE
WILL RISE TO 21 AND TURN OFF, IT WILL THEN COME BACK ON AGAIN
WHEN THE ROOM TEMPERATURE DROPS TO 19 DEGRESS.
•THE ROOM TEMPERATURE WILL MEASURED FROM WHEREVER YOUR
REMOTE IS PLACED
NOTE: DO NOT LEAVE THE REMOTE DIRECTLY IN FRONT OF THE HEATER,
PLACE TOWARDS BACK OF THE ROOM YOU ARE HEATING.
TO WATCH VIDEO -VISIT:
YOU-TUBE –COONARA THERMOSTAT