Cooper Lighting HALO DE600 User manual

311
TRACK LIGHTING Single Circuit
COOPER LIGHTING
HALO®
L904 L Connector
To connect two track sections at a right angle.
Field adjustable for either right hand or left hand
application. May be used as feed point.
Finish: White (P), Black (MB)
L906 X Connector
To connect four track sections into a cross
configuration. May be used as feed point.
Finish: White (P), Black (MB)
L908 Mini Joiner
A low profile connector to cleanly and crisply
join two straight track sections end-to-end.
(Note: The L908 is not a feed point).
Finish: White (P), Black (MB)
L950 Cord and Plug Connector
12’ three-wire cord with grounded plug.
Maximum capacity 10 AMP
Finish: White (P), Black (MB)
L979 Conduit Continuation Kit
Consisting of one left feed and one right feed.
To continue a run around obstructions. Designed
to accept 1/2” trade size conduit fitting (not
included).
Finish: White (P), Black (MB)
L983 T-Bar Attachment Clip
Allows track to be attached to inverted tee ceiling.
Order as follows: 2 kits for 2’ Trac; 2 kits for 4’
Trac; 3 kits for 8’ Trac and 4 kits for 12’ Trac.
L986 Mini-T Bar Clip
For mounting Trac on suspended ceilings with
mini-grid (9/16” wide) system.
L994 45° Pendant Adapter
For installing pendant mounted Power-Trac on
sloped ceiling. For use with L992 and L993.
Finish: White (P), Black (MB)
L905 T Connector
To connect three track sections into a T
configuration. Field adjustable for either right
hand or left hand application. May be used as
feed point.
Finish: White (P), Black (MB)
L907 Outlet Box for use with
T-Bar ceiling
L901, L903, L904, L905 or L906 connector also
required. 4”x 4” x 1 1/8”.
Finish: White (P), Black (MB)
L909 Floating Canopy and
Connector
Track can be connected to existing outlet
box located anywhere along the track. Comes
with canopy cover, connector, dead-end and
mounting hardware. 4 1/8” x 4 1/4” x 1 3/8”.
Finish: White (P), Black (MB)
L951 Wire Way Cover for Pendant
Assembly Kit
For track to be wired through stem (order one
for each feed point used). Shown with end
feed and pendant stem kit–order separately
Finish: White (P), Black (MB)
L980 Live End Conduit Adapter
Designed to accept standard 1/2” trade size
conduit fitting (not supplied). Use when
feeding to track through surface conduit
system.
Finish: White (P), Black (MB)
L992 Pendant Kit Assembly
Order 2 kits for 2’ Trac; 2 kits for 4’ Trac; 3 kits
for 8’ Trac; and 4 kits for 12’ Trac. Includes one
18” threaded steel stem, canopy and mounting
hardware.
L48 48” Steel Stem
For additional length with L992. Can be field cut.
Finish: White (P), Black (MB)
DE600 Dead End
Replacement Dead Ends for Single Circuit Track
(6 included)
Finish: White (P), Black (MB)