Coopers 9268 User manual

Plug-in Door Chime with Socket 9268 Instructions for Use
Please read and retain these instructions for future reference v002: 24/04/17
PARTS
1x Bell push
1x Plug In Receiver
1x Fixings pack (2 x screws, 2 x wall plugs and
adhesive pads)
1x 12V battery (23A)
TECHNICAL INFORMATION
Receiver: 230V, 50Hz
Bell push: 12V battery (23A)
Frequency: 433 MHz
INSTALLATION
Bell Push
Remove the back cover from the bell push.
Insert the battery according to the correct polarity
as shown in the battery compartment.
Take care to avoid damaging the other components
when inserting the battery.
To fix onto wooden doorframes or brick surfaces, insert
the screws (using wall plugs provided if required)
through the back cover, screw into place and then attach
the bell push. To fix, onto UPVC frames or plastic
surfaces, attach the back cover and then secure using
adhesive pads.
Receiver
Plug in the receiver and turn on at the mains.
Test the door chime by pressing the button on the
bell push.
CHIME SELECTION
Select the desired chime by pressing the button on
the side of the receiver. There are 16 chimes to
choose from.
WARNING
Maximum range: 75m
Do NOT fix the bell push on or near metal
surfaces as this can affect the transmission to
the receiver and reduce the operational range.
The building construction, walls, & doors can
also reduce the range of the door chime
depending on their material, thickness, etc.
Do NOT plug any appliances that use more
than 13A into the socket on the door chime.
It is advisable to test the door chime in the
desired location to check it operates correctly
before final installation.
No user serviceable parts. All repairs must be
undertaken by a qualified electrician.
This is NOT a toy. Keep away from children.
TROUBLESHOOTING
Problem
Potential cause
Potential solution
The door chime sounds continuously
The bell push button is jammed
Check button and release
The door chime doesn’t sound when
the bell push button is pressed.
The receiver is out of range
Move to a different location and re-test
The battery in the bell push
needs to be replaced/recharged
Replace or recharge with 1x 12V 23A
battery
PACKAGING
Dispose of packaging, paper and cartons separately from plastic bags at your local
recycling centre.
Dispose of item at the end of its lifespan at your local authorised household WEEE
waste recycling centre.