Core Lighting ALP-40 User manual

ALP-40 Surface Mount Slim LED Profile
INSTALLATION GUIDE
ALP40INSTALLGUIDE |P1
6WD΍&W*DUGHQD&$
LQIR#FRUHOLJKWLQJXVDFRP_ZZZFRUHOLJKWLQJXVDFRP
7_)
1
WARNING: RISK OF ELECTRICAL SHOCK
* turn off main power prior to installation
* make sure hands are dry
* never touch exposed wires
2
3
PLACE INSULATION ON BOTH ENDS OF THE LED
STRIP. PEEL OFF ADHESIVE BACKING AND ATTACH
ONTO PROFILE. MAKE SURE LED STRIP IS
COMPLETELY ADHERED TO PROFILE.
MOUNT DIFFUSER (LENS) ONTO PROFILE. LENS
WILL SNAP SHUT WHEN IT IS FULLY SET INTO
PLACE.
MOUNT END CAPS. FOR LEAD WIRE GOING
THROUGH THE END OF THE PROFILE, RUN LEAD
WIRE THROUGH END CAP WITH HOLE. USE AN END
CAP WITHOUT A HOLE FOR LEAD WIRES GOING
THROUG BOTTOM OF PROFILE.
End cap
End cap with hole

ALP-40 Surface Mount Slim LED Profile
INSTALLATION GUIDE
ALP40INSTALLGUIDE |P2
6WD΍&W*DUGHQD&$
LQIR#FRUHOLJKWLQJXVDFRP_ZZZFRUHOLJKWLQJXVDFRP
7_)
4
WARNING: RISK OF ELECTRICAL SHOCK
* turn off main power prior to installation
* make sure hands are dry
* never touch exposed wires
6
DETERMINE WHERE TO MOUNT THE FIXTURE THEN
MAKE 5MM HOLES AND INSERT ANCHORS. SCREW
MOUNTING CLIP ONTO PLACE SECURELY.
INSTALLATION COMPLETE
5
MAKE NECESSARY WIRE CONNECTIONS. MAKE
SURE TO FOLLOW WIRING DIAGRAM OF POWER
SUPPLY, DIMMER ETC... FIX PROFILE INTO POSITION
AND ATTACH TO MOUNTING CLIPS. FIXTURE WILL
SNAP SECURELY ONTO MOUNTING CLIPS WHEN
PROPERLY FASTENED.
LED-
LED+
DIM-
DIM+
Driver
GND
AC-N
AC-L
Connect to DIM
-
+
LED