Costway TW10009 User manual

EN DE FR ES IT PL
Fitness Trampoline
TW10009

Please read all instructions carefully and keep it for future reference.
Warnings:
Attention: For home use only.
Attention: The Product is not suitable for the children under 3 years
Danger: Keep all small parts and packaging materials for this product away from babies and
children, otherwise they may pose a choking hazard.
Danger: Lack of attachment may cause a risk of tipping or fall hazards.
General Warnings:
The product must be installed and used under the supervision of an adult.
Read through each step carefully and follow the proper order.
Remove all packaging, separate and count all parts and hardware.
Please ensure that all parts are correctly installed, incorrect installation can lead to a danger.
We recommend that, where possible, all items are assembled near to the area in which they will
be placed in use, to avoid moving the product unnecessarily once assembled.
Ensure a secure surface during construction, and place the product always on a flat, steady
and stable surface.
Please check and maintain regularly, the most important parts for suspension, fixing,
anchoring to the ground.
02

Parts List
N
r.
Parts Description Quantity
1Frame 1
2Jumping Mat 1
3Spring 32
4Protective Padding 1
5Leg 6
6Covering Cap 6
7Handrail Tube 5
8Kitbag 1
8
1
2
3
5
4
6
7
03

Before Assembly
Check all springs BEFORE assembly. If any spring is not attached or damaged, pls follow
below processes to attach or replace the spring.
A. Find the open end of the SPRING (#3) and hook this end into the hole on the Rail.
B. Swing the SPRING (#3) to face inside of the trampoline.
C. Attach the metal loop on the MAT (#2) to the spring hook.
Assembly Instruction
WARNING
1. Keep children away from the trampoline during assembly.
The RAILS will try to spring back to the folded position if they are released before the snap into place.
3. Assembly and disassembly must be carried out by two people to minimise the risk of injury.
STEP 1
La
forms a semi-circle.
2
04

STEP 2
Remove the bracket pins from both ends of the trampoline, and place them to the side.
STEP 3
PIN
PIN
A
B
C
D
Threaded Connector
Bracket
Rod
Two people press the rails C and D at the same time, and use steady pressure, with the fingers of both
hands extended, to push the rails A and B down until they touch the ground. Make sure that all joints are
locked into place.
05

STEP 4
STEP 5
Remove the covering cap on the threaded connector, and slide the protective padding (#4) over the
unfolded frame. Make sure the holes on the underside of the protective padding are positioned exactly
over the threaded connector for the feet. Make sure handle brackets are visible.
WARNING:
The protective pad must be securely
attached to the frame before using
the trampoline. It must be properly
positioned.
PIN
PIN
Insert the pin back into the bracket to prevent the rails from snapping together when it reaches the flat
position.
Threaded
Connector
Threaded
Connector
06

STEP 6
Turn the frame upside down. Screw the six feet onto the threaded connectors on the underside of the
frame. Turn the trampoline over and place it on its feet.
STEP 7
STEP 8
Connect tube D to top of both C tubes. Use spring button to secure C and D together. You now have a“ top
assembly”.
Rubber feet
Remove the rubber "feet" from the bottom of the two legs, then put the tube A on each leg, and then
replace the rubber feet.
07

STEP 9
Lower top assembly into both A tubes until bottom hole in top assembly lines up with hole at top of each A
STEP 10
Secure B knob to bottom of both A tubes.
08

STEP 11
To change height of handrail bar, remove E knob, move top assembly to desired height, then screw E knob
CARE AND MAINTENANCE
Inspect the trampoline before each use and replace any worn, defective or missing parts. The following
conditions could represent potential hazards:
1. Missing, improperly positioned, or insecurely attached frame padding.
2. Punctures, frays, tears, or holes in the bed, or frame padding.
3. Deterioration in the stitching or fabric of the bed or frame padding.
4. A bent or broken frame.
5. Sharp protrusions on the frame of suspension system.
4 adjustment holes
4 adjustment holes
09

Welcome to visit our website and purchase our quality products!


this product and giving us valuable feedbacks.
With your inspiring rating, COSTWAY will be more consistent to offer you
EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE!
US office: Fontana, California
UK office: Ipswich
Reward Points
Exclusive Customer Service

Permanent Shopping Cart
Order History
10