www.costway.com
Dealer: This manual MUST be given to the user of the Shower Chair/ Bench.
USER: Before using this Shower Chair/Bench, read this manual and save for
future reference.
GENERAL WARNINGS
Rubber tips MUST be in contact with tub floor at all times.
Always inspect the shower chair/bench to ensure that it is properly positioned
and stable before using. DO not use if it is wobbly or unstable.
Check rubber tips for rips, tears, crack or wear. lf any of these conditions exist,
replace rubber tips immediately.
The Shower Chair/Bench has a weight limitation of 150 kg.
ASSEMBLING
1. Put seat upside down on the ground / floor.
2. Align U-shaped tubes on the seat and then attach 4 legs accordingly as shown
in the figure.
The U-shaped tube 1 is placed in the direction of seat plate position 1 and the
U-shaped tube 2 is placed in the direction of seat plate position 2.
3. After aligning the holes in the overlapping area of the two U-shaped tubes,
install screws and washers to fix the two U-shaped tubes on the seat plate, and
then install the four legs.
Note: The incorrect placement of the 2 U-shaped tubes may cause unstable
installation.
①
②
③
⑤
⑥
U-shaped tube 1
U-shaped tube 2
Extension Leg
Seat
Screw M6*40
www.costway.com
02 03
Adjustment
Holes Snap Button
Leg Extension
Item Description
U-shaped tube 1
U-shaped tube 2
Screw M6*40
Washer
Seat
Extension Leg
①
②
③
④
⑤
⑥
1
1
5
5
1
4
Unit
ADJUSTING LEG EXTENSION
1. Select a hole which is suitable to you on the lower leg frame.
2. Depress the snap button and slide the adjustable legs up or down to the desired
height.
3. Ensure that the snap button is fully inserted into the tube's hole.
4. REPEAT STEP 2. 3. for the other legs
Make sure all four legs are adjusted to the same height so that the shower
chair / bench sits level
Hardware Package
NOTE: MAKE SURE ALL FOUR LEGS ARE ADJUSTED TO THE SAME
HEIGHT AND THE SEAT IS OPENED TO FULL EXPANSION BEFORE USE.
