Country Living Seneca 3 Piece Bistro Set AS-J-252-1R/3 User manual

OWNER’S
MANUAL
Date of purchase: _____/ _____/ _____
Seneca 3 Piece
Bistro Set
Product code: D71 M80231
UPC code: 7-6945575497-4
1
Vendor Item: AS-J-252-1R/3

2
PARTS
Read through all the instructions before beginning assembly. Unpack and identify all the parts.
Place them on a flat, non-abrasive surface. Assembly by two people is recommended.
C (1)
Tile
ACCESSORIES
Ha (1 spare)
Short Bolt
Hb (4)
Long Bolt
Hc (1 spare)
Metal Washer
He (1)
Allen Wrench
B (4)
Leg
Hf (1)
Hex Wrench
D (2)
Rocker Top
F (2)
Base
Hd (4)
Lock Wahser
Hg (1)
Assembly
Instructions Sheet
E (2)
T Shaped
Connector
G (2)
Center Post
A (1)
Table Rim
(12 Metal Washers
and 12 Bolts attached)

3
ASSEMBLY INSTRUCTIONS
Place the rocker top (D) upside down on
your non-abrasive work surface. Attach
the T shaped connector (E) to the bottom
of the rocker seat by inserting a long
bolt (Hb) through a lock washer (Hd),
through the connector and into the rocker
seat for each hole. See Fig. 1. Securely
tighten the bolts.
Align the connector of the assembled rocker
seat (D, E) with the hole in center post and
push the rocker seat down firmly until fully
engaged. See Fig. 3. Repeat procedure for
the other rocker.
Place the base (F) on flat surface, and
insert the center post (G) into the hole
located at the center of the base (F).
See Fig. 2. Push the center post (G)
down firmly and twist it left and right
as necessary.
1
2
3
ROCKER ASSEMBLY
Fig. 1
Fig. 2
Fig. 3
G
F
E
D
Hb
Hd

4
CARE INSTRUCTIONS
Wash with a mild solution of soap and water; rinse thoroughly. Dry completely. Do not use bleach or solvents.
Cover furniture with outdoor furniture covers when not in use.
Made in CHINA
Distributed by Sears, Roebuck and Co., Hoffman Estates, IL 60179
See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com
For questions or comments about product:
Call toll-free:
800-457-4652
Please refer to part numbers when reordering
sears.com
Place the table rim (A) upside on a flat surface.
Remove all bolts (Ha) and metal washers (Hc) that
are attached to the table rim. Attach a leg to the table
rim (A). Align the holes, for each hole insert a short
bolt (Ha) through a metal washer (Hc), through the
bracket of the metal leg (B) and secure into the
table rim (A). See Fig. 4. Don’t tighten completely.
Repeat procedure for the other three legs.
Securely tighten all bolts by using Allen wrench (He).
Turn the table over and place the tile (C) onto the
table rim. See Fig. 5.
Your table and rockers are now ready to use.
TABLE ASSEMBLY
4
5
Hc
B
A
Ha
C
A
B
Fig. 4
Fig. 5