CoverCraft CARVER Bimini Top Instruction Manual

1. Unzip the canvas and place it around the A-bow at the light cut-out.
2. Begin closing the zipper. Slowly pull more canvas together until the zipper is
completely closed around the top of the A-bow.
3. Proceed to the B-bow and repeat Step 2.
4. Proceed to the two center bows and repeat Step 2.
5. Center the canvas on the frame.
Zippers make it easy to
remove canvas for cleaning and
installing on your existing frame.
Installing a Carver Replacement Canvas for
Square-Tube Pontoon Frames
More Information at CarverCovers.com
or call (888) 48-COVER.
The Best Covers Under the Sun™
Carver by Covercraft Industries, LLC 212 N. Lyles Ave., Landrum, SC 29356
Please take extra care when
unpacking and installing your
Bimini Top canvas. Should you
need to return the Bimini Top
canvas, it MUST be in its original,
new condition. The Bimini Top
canvas must be clean and dry, and
free of debris (including pet hair).
Light Cut Out
Center Bows
B-Bow
A-Bow
• Avoid letting water or snow
stand on the Bimini Top
• Always travel with the top in
the stored position.
• Allow the Bimini Top to dry
thoroughly before folding for
storage.
How to Prolong
the Life of Your
Bimini Top
#3057519 (09/20)

More Information at CarverCovers.com
or call (888) 48-COVER.
The Best Covers Under the Sun™
Carver by Covercraft Industries, LLC 212 N. Lyles Ave., Landrum, SC 29356
Carver by Covercraft®Limited Warranty
The materials and workmanship in Carver by Covercraft Industries, LLC. products are guaranteed to be free of
defects at time of manufacture. The length of the warranty is determined by the type of material ordered. Please
visit our website, www.carvercovers.com, for material choices and length of warranty for boat covers, PWC covers
and bimini tops, or refer to the material list below.
Warranty coverage commences on the original date of consumer’s purchase. The warranty does not cover normal
wear, weather soiling, stains from environmental pollution and/or standing water, cuts from sharp objects, neglect,
accident or misuse. The boat cover, PWC cover, Bimini Top or accessory must be properly installed, utilized and
maintained. The warranty is non-transferable.
If a defect is detected within 6 months of date of purchase, Carver by Covercraft Industries, LLC. will repair or
replace (at its discretion) the product free of charge. If a defect is detected after 6 months and up to 36 months from
date of purchase for three-year warranties, and up to 60 months from date of purchase for five-year warranties,
and up to 84 months from date of purchase for seven-year warranties, Carver by Covercraft Industries, LLC. will
(at its discretion) repair the defect on a time and material cost basis or replace the product on a pro-rated basis.
Carver by Covercraft Industries, LLC. and/or seller provide this warranty in lieu of all other warranties, expressed
or implied. Carver by Covercraft Industries, LLC. and/or seller disclaim all liability for special, incidental or
consequential damages.
Some states/provinces do not allow limitations on how long implied warranty lasts, or the exclusion or limitation
of special, incidental or consequential damages, so these limitations and exclusions may not apply to you. This
warranty gives you specific legal rights. You may also have other rights which vary from state/province to state/
province.
Warranty Claims
Call before returning product to receive a Return Merchandise Authorization Number (RMA#),
then send warranty claims to:
Phone: (888) 48-COVER
Mailing/Shipping Address: Carver by Covercraft, 212 N. Lyles Ave., Landrum, SC 29356
Please enclose a note describing the defect and be sure to include your full name and address inside the package.
Length of Warranty by Fabric
Material Term
9.25 oz. Solution Dyed Acrylic 10 years
7 oz. Sun-DURA™7 years
8 oz. Performance Poly-Guard®5 years
14 oz. Vinyl 5 years
#3057519 (09/20)