CP TECHNOLOGIES POS-1001 User manual

POI-2001 & POS-1001
Gigabit PoE Injector & Splitter
POI-2002 & POS-1002
PoE Injector & Splitter
POI-3004
Gigabit PoE Injector
POI-3000 & POS-3000
Gigabit PoE Plus Injector & Splitter
POI-3002 & POS-3000
PoE Plus Injector & Splitter
Quick Installation Guide

Installation Steps
Connect AC Power cord to the PoE Injector, and "Power" LED will light up.
Step 1.

Connect "Data/In" port of Injector to Non PoE switch via Cat.5e/6/7 cable, and set the
correct voltage (5V, 9V or 12V) by adjustable DIP switch on the side of PoE Splitter.
(default setting 5V)
Step 2.
Connect “Power+Data” port of Splitter and "P+D/Out" port of Injector via Ethernet cable,
and make sure "Power" LED of Splitter is on.
Step 3.
Connect "Power OUT" cable of Splitter to power jack of he network device, and connect
"Data OUT" cable of Splitter to RJ45 port of network device.
(Please ensure to choose the right interchangeable tip for powering the non PoE
devices.)
Step 4.
Check whether the network device is on. If not, please make sure that power is on for
Injector and Splitter, and all cables are connected correctly.
S tep 5.