Craftsman ROW CROP CULTIVATOR 486.242051 User manual

ROW CROP CULTIVATOR
Model No. 486.242051
Owner's Manual
CAUTION:
Before using this product, read
this manual and follow all
Safety Rules and
Operating Instructions.
•Safety
•Assembly
•Operation
•Maintenance
•Parts
PRI TED I U.S.A. FORM O. 48337 (7/04)
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
www.sears.com/craftsman
IMPORTANT - READ THIS FIRST!!!
For Missing Parts or Assembly Questions
Please Call 866-576-8388
Mon.-Fri. 7 am - 5 pm CST.
FAX [phone] or e-mail [email protected]
Missing parts will be sent UPS in 24 hours directly to your home.
®

2
MODEL UMBER: 486.242051
SERIAL UMBER: __________________
DATE OF PURCHASE: __________________
TABLE OF CONTENTS
The model and serial numbers will be found on a decal
attached to the
You should record both the serial number and the date of
purchase and keep in a safe place for future reference.
LIMITED ONE YEAR WARRANTY ON CRAFTSMAN CULTIVATOR
For one year from the date of purchase, when this row crop cutlivator is maintained and lubricated according to the
operating and maintenance instructions in the owner's manual, Sears will repair any defect in material or workman-
ship free of charge. If this row crop cultivator is used for commercial or rental purposes, this warranty applies for only
90 days from the date of purchase.
This warranty does not cover repairs necessary because of operator negligence or abuse, including the failure to
maintain the equipment according to instructions contained in the owner's manual.
WARRA TY SERVICE IS AVAILABLE BY CO TACTI G THE EAREST SEARS SERVICE CE TER/DEPART-
ME T I THE U ITED STATES.
This warranty applies only while this product is in the United States.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co. D/817 WA. Hoffman Estates, Chicago, IL 60179
WARRANTY
Safety Rules............................................................ 2
Warranty ................................................................. 2
Full Size Hardware Chart........................................ 3
Assembly ................................................................ 4
Operation ................................................................ 4
Maintenance ........................................................... 4
Storage ................................................................... 4
Repair Parts Illustration .......................................... 5
Repair Parts List ..................................................... 5
Parts Ordering/Service ........................... Back Cover
SAFETY
Any power equipment can cause injury if operated improperly or if the user does not understand how to operate
the equipment. Exercise caution at all times, when using power equipment.
•Read this owners manual and your vehicle and
sleeve hitch owners manuals before using this
equipment.
•Do not allow children to operate vehicle or cultiva-
tor.
•Do not allow adults to operate vehicle or cultivator
without proper instructions.
•Do not allow anyone to ride on the cultivator.
•Before lowering and operating the cultivator, be
sure no one is near the area of operation.
•Lower cultivator when leaving vehicle unattended.
•Vehicle braking and stability may be affected with
the attachment of this equipment. Drive slowly with
cultivator in transport position. Stay off of steep
slopes.
•Stop and inspect for damage after striking an
object. Repair any damage before continuing
operation.
•Keep all nuts and bolts tight and be sure that the
equipment is in safe operating condition.
•Lock tractor lift handle in down position when
attaching or removing cultivator from sleeve hitch.
Look for this symbol to point out important safety precautions. It means--Attention!!
Become alert!! Your safety is involved.

3
HARDWARE PACKAGE CONTENTS
FULL SIZE HARDWARE CHART
AB
CE
D

REF. QTY. DESCRIPTION
NO.
A 5 Hex Bolt, 3/8-16 x 2-1/2" Lg.
B 9 U-Bolt, 3/8-16 Thread
C 23 Hex ut, 3/8-16 Thread
D 10 Flat Washer, 3/8" Std. Wrt.
E 23 Lock Washer, 3/8"
CARTON CONTENTS
1. Depth Gauge Bar (2)
2. Frame Assembly
3. Cultivator Tang (7)
4. Hitch Assembly
4
2
13

4
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2) 9/16" Wrenches
Refer to the illustration on page 5 and the full size
hardware chart on page 3. Be sure to place a 3/8" flat
washer under any bolt head or lock washer which
otherwise would tighten down directly against a frame
tube or the hitch assembly.
•Attach the hitch assembly to the frame using five
3/8" x 2-1/2" hex bolts, ten 3/8" flat washers, five
3/8" lock washers and five 3/8" hex nuts.
Tighten.
•Assemble seven cultivator tangs to the frame tubes
using seven U-bolts with fourteen 3/8" lock wash-
ers and 3/8" hex nuts. The alignment of rear
tangs should be offset from front tangs. Tighten.
NOTE: The arrangement and the number of tangs
can vary as long as the balance of the cultivator
is maintained.
•Assemble the depth gauge bars to the rear of the
frame using two U-bolts with four 3/8" lock wash-
ers and 3/8" hex nuts. Attach each bar using the
set of holes on the bar that will provide the desired
depth of tang penetration. Tighten.
NOTE: For effective depth control do not position a
depth gauge bar directly behind a front tang.
ATTACHING CULTIVATOR TO TRACTOR
Refer to your sleeve hitch owners manual.
•Attach the cultivator to the sleeve hitch on your
tractor using the sleeve hitch pin.
•Tighten the two stabilizer bolts and jam nuts to
eliminate looseness in the hookup.
•Adjust the sleeve hitch so that the cultivator is free
to go below ground level but can still be raised an
adequate distance above ground for transport.
•Loosen the stabilizer bolts and jam nuts before
removing the cultivator from the sleeve hitch.
CAUTION: Lock the tractor lift handle in
down position when attaching or removing
the cultivator from the sleeve hitch.
OPERATION
The cultivator may be used for breaking up compacted
soil, for working loose soil and for cultivating between
crop rows. For improved traction use wheel weights
and/or tire chains.
•Drive at a slow speed when cultivating soil.
•Adjust or remove cultivator tangs as needed for
working between rows.
•Adjust working depth of tangs by raising or lower-
ing the depth gauge bars. Select the appropriate
set of adjusting holes for conditions.
•Up to 100 lbs. of concrete blocks or other weight
may be strapped or tied to the cultivator frame to
improve tang penetration. The cultivator should be
attached to the tractor's sleeve hitch (in down
position) before adding weight.
•Do not back up when cultivator is engaged in soil.
STABILIZER BOLTS
TRACTOR SLEEVE HITCH

5
•Check for loose bolts after each use.
•Clean the tangs after each use and lightly oil any
exposed metal.
•Remove all dirt and rust and touch up with paint
before storing.
•Store inside a dry area.
CUSTOMER RESPONSIBILITIES
Read and follow the procedures listed in this section.
MAINTENANCE/STORAGE
PARTS
REPAIR PARTS FOR MODEL 486.242051
4
3
4
1
5
5
6
7
67
7
6
7
6
6
8
8
79
9
8
2
8
REF. PART QTY. DESCRIPTION
NO. NO.
1 63656 1 Hitch Ass'y.
2 64279 1 Frame Assembly
3 43022 7 Cultivator Tang
4 24238 2 Depth Gauge Bar
REF. PART QTY. DESCRIPTION
NO. NO.
5 43432 5 Hex Bolt, 3/8-16 x 2-1/2" Lg.
6 43015 23 Hex ut, 3/8-16 Thread
7 43003 23 Lock Washer, 3/8"
8 46853 9 U-Bolt, 3/8-16 Thread
9 43070 10 Flat Washer, 3/8" Std. Wrt.
48337 1 Owners Manual

6
NOTES

7
NOTES

Get it fixed, at your home or ours!
For repair of major brand appliances in your own home…
no matter who made it, no matter who sold it!
1-800-4-MY-HOME
SM
Anytime, day or night
(1-800-469-4663)
www.sears.com
To bring in products such as vacuums, lawn equipment and electronics
for repair, call for the location of your nearest Sears Parts & Repair Center.
1-800-488-1222 Anytime, day or night
www.sears.com
For the replacement parts, accessories and owner’s manuals
that you need to do-it-yourself, call Sears PartsDirect
SM
!
1-800-366-PART 6 a.m. – 11 p.m. CST,
(1-800-366-7278) 7 days a week
www.sears.com/partsdirect
To purchase or inquire about a Sears Service Agreement:
1-800-827-6655
7 a.m. – 5 p.m. CST, Mon. – Sat.
Para pedir servicio de reparación a domicilio,
y para ordenar piezas con entrega a domicilio:
1-888-SU-HOGAR
SM
(1-888-784-6427)
Au Canada pour service en français:
1-877-LE-FOYER
SM
(1-877-533-6937)
© Sears, Roebuck and Co.
® Registered Trademark / ™ Trademark of Sears, Roebuck and Co.
® Marca Registrada / ™ Marca de Fábrica de Sears, Roebuck and Co.
HomeCentral
SM