CraftUnique CraftBot XL User manual

1
CraftBot
PETG DOME COVER
INSTALLATION MANUAL

2
CraftBot
HARDWARE
1. First, unplug the machine. Then, care-
fully remove the rear panel of the
printer, using care with the case fan ca-
ble (red-black-yellow). Place the dome
cover on top of the machine, but do
not screw it together yet.
2. The next step is to disconnect the case
fan.

3
CraftBot
3. Connect the appropriate end of the “Y”
wire of the dome cover fan to the case
fan socket.
4. After that, connect the case fan con-
nector to the other end of the “Y” wire.

4
CraftBot
FIRMWARE SETTINGS
• In the temperature setting menu, by pressing the icon, the dome cover settings menu will be
displayed.
• Here, with the ON / OFF button, you can enable or disable the operation of the dome fan. This
feature setting will not change when the printer is turned o and on.
5. Finally, screw in the rear panel and the
dome cover. The correct location of the
lament guide tube and the fan wiring
are shown in the following gures.