Malyan M150 User manual

MALYAN M150 FRIST RUN EXPERIENCE
Safety Information
1.1 Caution: The Malyan M150 generates high temperatures and includes moving parts that can
cause injury. Never reach inside The Malyan M150 while it is in operation, and allow time for
The Malyan M150 to cool down after operation.
The Malyan M150 is sensitive to electrostatic discharge. Make sure you don't have a static charge
on you by touching a grounded object before operating The Malyan M150 or attempting any
adjustments. If opening The Malyan m150 for service, ensure that the power supply is turned off
and the cord is disconnected.
All set
First, make sure that you`ve completed all the steps in the Unboxing and Hardware Setup section:
your step extruder should be bolted in place, your filament spool amounted, and your
spools of filament mounted on the spool holders. You can plug in your power supply now, too. 2.1
If everything is ready, then flip on the power button on the back of your Malyan M150 and hold
onto your hat. Not literally, though -- if this causes a large gust of wind, you should probably
contact tech support at [email protected] .
The Malyan M150 will now guide you through initial setup and your first print. You should see a
MALYAN LOGO on the LCD screen. 2.2